Toshiba B-SA4TM SERIES, EO1-33047 owner manual Setting the Feed Gap Sensor position

2. PRINTER SETUP

ENGLISH VERSION EO1-33047

2.3 Loading the Media

2.3Loading the Media (Cont.)

11.After loading the media, it may be necessary to set the position of the Media Sensor used to detect the print start position for label or tag printing.

Setting the Feed Gap Sensor position

When using a label stock without black marks, the Feed Gap Sensor is used to detect a print start position.

(1)Push the Upper Sensor Lever inside and open the Upper Sensor Ass’y.

(2)Slide the Lower Sensor Tab with your finger to move the Feed Gap Sensor so that the Feed Gap Sensor is positioned at the centre of the labels. ( { indicates the position of the Feed Gap Sensor).

It may be easier to move the Lower Sensor Tab when using a pen with its tip inserted into the pinhole of the tab.

NOTE:

Be sure to align the Upper Feed Gap Sensor with the Lower Feed Gap Sensor. Failure to do this cause a paper jam error.

Feed Gap	Pinhole
	Lower Sensor Tab
Sensor

(3)Lower the Upper Sensor Ass’y until the Upper Sensor Lever clicks into position.

(4)Slide the Upper Sensor Tab to move the Feed Gap Sensor so that it aligns with the lower Feed Gap Sensor.

Feed Gap Sensor

Upper Sensor Tab

E2- 6