Toshiba B-SA4TM SERIES, EO1-33047 owner manual Label or Thin media

2. PRINTER SETUP

ENGLISH VERSION EO1-33047

2.3 Loading the Media

2.3Loading the Media (Cont.)

WARNING!

The cutter is sharp, so care must be taken not to injure your fingers when handling the cutter.

CAUTION!

1.When using a label stock, be sure to cut the gaps. Cutting labels will cause the glue to stick to the cutter, which may affect the cutter quality and shorten the cutter life.

2.Use of tag paper which thickness exceeds specified value may affect the cutter life. For the specification of the media, refer to Section 7.1 Media.

NOTES:

1. Be sure to set both Head

Pressure Adjustment Levers in

the same direction. Failure to

do this may cause blurred

printing.

2. Do not leave the Head Pressure

Adjustment Levers positioned at

the middle. When closing the

Top Cover, they block the Print

Head Positioning Shaft, and the

Top Cover cannot be closed.

Print Head Positioning Shaft

Cut mode (Option)

When the optional Cutter Module is fitted, the media is automatically cut.

Insert the leading edge of the media into the Media Outlet of the Cutter Module.

Media

13.Change the print head pressure according to the thickness of the media to be used, by using the Head Pressure Adjust Lever.

cd

Head Pressure

Adjustment Lever

		Head Pressure
	d	Adjustment Lever
c

Media type or thickness

Label or Thin media

cIf a clear print cannot be obtained, change the position to d.

Tag paper or Thick paper

dIf a clear print cannot be obtained, change the position to c.

Head Pressure

Adjustment Lever

Move the levers toward the front of the printer.

Move the levers toward the back of the printer.

Head Pressure Adjust Lever

14.If the loaded media is direct thermal media (with a chemically treated surface), the media loading procedure is now completed. Close the Top Cover.

If the media is normal media, it is also necessary to load a ribbon. Refer to Section 2.4 Loading the Ribbon.

E2-10