Toshiba B-SA4TM SERIES, EO1-33047 owner manual Supply Specifications

7. SUPPLY SPECIFICATIONS

ENGLISH VERSION EO1-33047

7.1 Media

7. SUPPLY SPECIFICATIONS

7.1 Media

Please make sure that the media being used is approved by TOSHIBA TEC. The warranty does not apply when a problem is caused by using media that is not approved by TOSHIBA TEC.

For information regarding TOSHIBA TEC approved media, please contact a TOSHIBA TEC authorised service representative.

7.1.1 Media Type

Two types of media can be loaded for this thermal transfer and direct thermal printer: label or tag. The table below shows size and shape of the media available for this printer.

	Black Mark		Black Mark
Label	(on reverse side)	Tag paper	(on reverse side)

Stop position k

Cut position

j

i f e

Stop
position k
h g	h
Cut position
c	c
d
	i
Feed Direction	e
	[Unit: mm]

	Label dispensing mode		Batch mode	Strip mode		Cut mode
Item
c Media pitch		Thermal direct	10.0 – 999.0	19.0	– 999.0	19.0 - 999.0
		Thermal transfer	15.0 – 999.0
d Label length		Thermal direct	8.0 – 997.0	17.0	– 997.0	16.0 – 997.0
		Thermal transfer	13.0 – 997.0
e Media width/backing paper width		Thermal direct		25.0	– 118.0
		Thermal transfer		25.0	– 114.0
f Label width		Thermal direct		22.0	– 115.0
		Thermal transfer		22.0	– 111.0
g Gap length			2.0 – 20.0	2.0 – 5.0		3.0 – 20.0
h Black mark length (Tag paper)				2.0	– 10.0
i Maximum effective print width			104.0 (200-dpi type), 105.7 (300-dpi type)
	Label	Thermal direct	6.0 – 995.0	15.0	– 995.0	14.0 - 995.0
j Effective print length		Thermal transfer	11.0 – 995.0
	Tag paper	Thermal direct	8.0 – 997.0	-----		17.0 – 997.0
		Thermal transfer	13.0 – 997.0
k Print speed up/slow down area					1.0
Thickness		Thermal direct	0.08 – 0.17 (Note 4)	0.13 – 0.17		0.08 – 0.17 (Note 4)
		Thermal transfer	0.1 – 0.17 (Note 4)	0.13 – 0.17		0.1 – 0.17 (Note 4)
Maximum outer roll diameter				Ø200
Roll direction				Inside/Outside
Inner core diameter				Ø38, 40, 42, 76.2±0.3

E7- 1