Toshiba EO1-33047, B-SA4TM SERIES owner manual Loading the Media

2. PRINTER SETUP

ENGLISH VERSION EO1-33047

2.3 Loading the Media

2.3 Loading the Media

WARNING!

1.Do not touch any moving parts. To reduce the risk of fingers, jewellery, clothing, etc., being drawn into the moving parts, be sure to load the media once the printer has stopped moving completely.

2.The Print Head becomes hot immediately after printing. Allow it to cool before loading the media.

3.To avoid injury, be careful not to trap your fingers while opening or closing the cover.

CAUTION!

1.Make sure that the Upper Sensor Ass’y is closed when taking out the Media Holder Ass’y. If the Upper Sensor Ass’y is opened, it may be damaged.

2.Be careful not to touch the Print Head Element when opening the Top Cover.

Failure to do this may cause missing dots by static electricity or other print quality problems.

NOTE:

1.As the Top Cover is heavy, be sure to support it with your hand when opening it. Failure to do this may cause the printer to fall over backward.

2.For the specification of available media, refer to Section 7.1 Media.

3.When the inner core diameter of the media roll is 40 mm, remove the Spacers from the Media Holders.

The following procedure shows the steps to properly load the media into the printer so that it feeds straight and true through the printer.

Use the same procedure when replacing the media, also. The printer prints both labels and tags.

1.Press the Top Cover Release Button and gently open the Top Cover to its fully open position supporting it with your hand.

Top Cover

Top Cover Release Button

2.Take out the Media Holder Ass’y from the printer.

Media Holder

Ass’y

Upper Sensor

Ass’y

3.Raise the Release Lever and remove the Media Holder (Left).

Media Holder (Left)

Release Lever

4.Insert the Media Shaft into the core of a media roll.

Media Shaft

Spacer

E2- 3