Using the menu (Continued)
Displaying Information (Status display)
This displays information about the input signal, lamp use time, etc.
“Yes”: displayed, “No”: not displayed
Item | Description |
Input | Input source name |
Mode name | RGB input mode [Note 1] |
Horizontal resolution (in dots) | |
Vertical resolution (in dots) | |
Horizontal sync frequency | |
Vertical sync frequency [Note 2] | |
Sync | Sync signal polarity [Note 3] |
Signal format | Y/PB/PR signal format |
Video mode | Color method of video signal |
Lamp time | Time of lamp use [Note 4] |
Lamp reset count The count for lamp replacement | |
Total time | The total time that this projector is used |
Version | Firmware version [Note 5] |
Notes
Computer | Y/PB/PR | Video | |
|
| ||
Yes | Yes | Yes | |
Yes | No | No | |
Yes | No | No | |
Yes | No | No | |
Yes | No | No | |
Yes | No | No | |
Yes | No | No | |
No | Yes | No | |
No | No | Yes | |
Yes | Yes | Yes | |
Yes | Yes | Yes | |
Yes | Yes | Yes | |
Yes | Yes | Yes |
1:The mode of supported RGB signals p. 39 is shown.
2:Same as the refresh rate of the computer signal.
3:Sync signal polarity shown as P (positive) or N (negative) for [H/V].
4:Displays [Lamp time] as a measure of when the lamp should be replaced. (Cannot be used as a counter of guaranteed lamp time.) When the displayed time approaches 2,000 hours, consult with a store about getting a TLPLP8 replacement lamp (sold separately) prepared.
5:[Version] shows the version of the projector’s internal control program. This version is referred to for customer service, etc.
Note
•The displayed information will not be refreshed if the status changes. To refresh the information, dismiss the display, then display it again.
34