Appendices (Continued)
Replacing the lamp
Warning: Lamp
compartment is hot! Allow it to cool down before changing lamp!
The projector will detect the lamp life itself. It will show you a warning message “The Lamp life is ending” When you see this message, change the lamp.
Make sure the projector has been cooled down for at least one hour before changing the lamp.
1 | 3 |
2 | 4 |
|
Warning: To
reduce the risk of personal injury, do not drop the lamp module or touch the lamp bulb. The bulb may shatter and cause injury if it is dropped.
Lamp Replacing Procedure:
1.Switch off the power to the projector by pressing the Power button twice.
2.Allow the projector to cool down at least 1 hour.
3.Disconnect the power cord.
4.Use a screwdriver to remove the screw from the cover.
5.Push up and remove the cover.
6.Remove the 2 screws from the lamp module.
7.Pull out the lamp module.
To replace the lamp module, reverse the previous steps.
8. Reset the lamp timer.
Used Lamps
This projector’s lamps contain trace amounts of environmentally harmful inorganic mercury. Be careful not to break used lamps, and dispose of them in accordance with local regulations.
38