Toshiba TDP-P8 manual Turning the power off Press the ON/STANDBY button

Page 24

Installation (Continued)

•The ﬁ rst time you use the projector after purchase, after the start-up screen, please press “MENU” button.

Turning the power off

Press the ON/STANDBY button.

A message appears on the screen, conﬁ rming that you wish to shut off the power. This message will disappear after a moment. (This operation is no longer valid after the message disappears.)

Press the ON/STANDBY button again.

If the screen turns off, but the internal cooling fan continues to operate for a short while. Then, the projector goes into standby mode.

When cooling lampAfter cooling complete

AB

ADuring cooling, the POWER indicator ﬂ ashes. In this state, the power cannot be turned back on.

If you are in a hurry, there is no problem with unplugging the power cord

or turning off the power consunption in this state. In standby mode.

Note

•The projector consumes about 3-4W of power in standby. We recommend that you unplug the power cord or turn off the main power switch if you will not be using the projector for an extended period.

PRECAUTION

•If the power cord is unplugged before cooling is complete, give the lamp time (about 5 minutes) to cool before plugging it back in. If the lamp overheats, it may fail to light

25

Image 24

Contents Safety Precautions Model Name TDP- P8 USA onlyPage Important Safety Instructions Power SourcesSource of Light VentilationPower-Cord Protection CleaningHeat Water and MoistureImportant Safety Instructions Accessories Damage Requiring ServiceServicing Important Safety Instructions Replacement PartsSafety Check Do not use the product Closed installation statePower Supply Cord Selection Important PrecautionsPlace and Manner of Installation Save Original Packing MaterialsImportant Precautions Exemption ClausesAvoid Volatile Liquid Other Cautions and Informations CopyrightsDisposal TrademarksRemote Control Batteries Table of Contents Installing Acrobat Reader IntroductionPackage Overview Viewing the manualProduct Overview Main UnitControl Panel Connection Ports Control Panel & Remote Control User ControlsRemote Control Front RearPreparing and using the remote control Loading dry-cell batteries into Remote controlOperating the remote control Switching operation mode Switching the remote control operation modeOperating a computer using the remote control Installation Connecting the ProjectorTurning the power on and off Turning the power on Press the ON/STANDBY buttonTurning the power off Press the ON/STANDBY button Press the ON/STANDBY button againAdjusting the Projected Image Adjusting the Projector Image HeightAdjusting the Projector Zoom / Focus Adjusting Projection Image SizeAdjusting the screen size and focus Using the menus How to use the menusPress the Menu ButtonUsing the menu Image adjustment menuDisplay setting menu Screen sizeBlue Default setting menu Manual adjustments and settings Displaying Information Status display Trouble shooting Problem No image appears on screenProblem Partial, scrolling or incorrectly displayed image AppendicesProblem Image is unstable or ﬂickering Problem Image has vertical ﬂickering barProblem Image is out of focus Problem The image is stretched when displaying 16 9 DVDProblem Image is reversed Problem Lamp burns out or makes a popping soundLamp Replacing Procedure Replacing the lampTo replace the lamp module, reverse the previous steps Used LampsAppendices Computer Compatibility Analog RemarkSpeciﬁcations List of general speciﬁcationsConnection terminal When the lamp is broken About LampAbout Lamp Lamp replacement Lens cleaningMain unit cleaning