Toshiba TDP-S9 owner manual Placement Styles, Projection Distance and Size

Placement

Placement Styles

As shown in the figures below, this device can be placed in 4 different styles.

The factory setting is “floor-mounted front projection.” Set the projection type in the Advanced menu p.32 , in accordance with your needs.

Floor-mounted front projection

Floor-mounted rear projection

Ceiling-mounted front projection Ceiling-mounted rear projection

WARNING

•Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when placing the unit. Attempting to clean/replace the lamp at a high site by yourself may cause you to drop down, thus resulting in injury.

•If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so. Mounting the projector on a ceiling requires special ceiling brackets (sold separately) and specialized knowledge. Improper mounting could cause the projector to fall, resulting in an accident.

•If the projector is ceiling-mounted, install the breaker for turning off the power in case of anomaly. Let everyone involved with the use of the projector know that fact.

Projection Distance and Size

Use the figures, tables, and formulas below to determine the projection size and projection distance. (Projection sizes are approximate values for full-size picture with no keystone adjustment.)

Screen As seen from above	a (min length) = projection size (inches) x 0.03636
90°￿	a (max length) = projection size (inches) x 0.04363
		projection	projection distance a (m)		height (H)
			min length	max length
		size (inches)			(cm)
As seen from the side			(zooming max)	(zooming min)
		27.5	-	1.2	5.9
Lens center		40	1.5	1.7	8.5
		50	1.8	2.2	10.7
H		60	2.2	2.6	12.8
		80	2.9	3.5	17.1
90°￿		100	3.6	4.4	21.3
a		150	5.5	6.5	32.0
a is the distance (m) between the lens and the		200	7.3	8.7	42.7
		229	8.3	10.0	48.9
screen, and corresponds to a range of 1.20 m to		275	10.0	-	58.7
10.00 m. H is the height from the image bottom to the
center of the lens.

Preparations

19