Toshiba TDP-S9 Unplug power cord Wait until lamp is sufficiently cooled, Remove the lamp cover

Page 35

1Unplug power cord.

2Wait until lamp is sufficiently cooled.

Wait for at least 1 hour.

3Remove the lamp cover.

Loosen the screws on the lamp cover and remove the lamp cover.

4Pull out the lamp.

Loosen the screws on the bottom of the lamp assembly. Grasp the lamp handle and pull the lamp assembly directly out of the projector.

5Mount the new lamp.

Align the orientation, press down until the bottom is reached, and lock in place using the lamp locking screws.

6Replace the lamp cover.

Align the cover, and press it in, then tighten the screws loosened in step 3 until the lamp cover is no longer loose.

3

4

5

1

1

Lamp cover

2

1

2

2

2

1

Notes and Precautions

•Attach the lamp cover correctly so that it is not loose. If it is not attached correctly, the lamp may fail to come on p.37 , and the lamp’s lifetime may be shortened.

•Always replace the lamp with a new one.

•The lamp is made out of glass. Do not touch the glass surface with your bare hands, bang it, or scratch it. (Dirt, jolts, scratches and the like could break the lamp.)

■Lamp Hours Reset

1Select “Factory Reset” option in the Advanced menu.

2Press control panel’s “+” Button 3 times and “–” button 3 times.

3Lamp Hours will be automatically reset.

Maintenance

35

Image 35

Contents TDP-S9 Svga USA only Safety PrecautionsBefore Using Source of Light Important Safety InstructionsHeat Lightning storms Important Safety InstructionsAccessories Replacement Parts Save Original Packing Materials Power Supply Cord SelectionImportant Precautions Place and Manner of InstallationExemption Clauses Important Precautions Avoid Volatile LiquidOther Cautions and Informations Remote Control BatteryContents Others MaintenanceChecking the package contents Preparations Names of each part on the main unitNames of each part on the control panel and remote control Parts on the rear panel Operating the remote Control Preparing and using the remote controlLoading a Lithium battery into the remote control Projection Distance and Size PlacementPlacement Styles Before connection ConnectionRemoving the lens cover Turning the power on and offConnecting the power cord Turning the power onPress the I/ ON/STANDBY button again Turning the power offActivate the connected device Turn on the powerBasic operations Select the languageTo adjust the horizontal angle, use the tilt adjuster Projector placement angle adjustmentsAdjusting the screen size and focus Correcting the keystone distortion Keystone Using handy featuresManually selects an input source Source Cutting off the sound temporarily Mute Automatically adjusts frequency and phase AutoSwitching the image aspect ratio 43/169 Press the remote controls Mute buttonHow to use the menus Using the menusImage menu Using the menuSharpness Video menuSaturation TintPosition PhaseDisplay menu TrackingLanguage Language menuAdvanced menu Using the menuMute VolumeAudio menu About lamp Lamp replacementImmediately replace the lamp when Lamp LED lights amber When the lamp is brokenPull out the lamp Unplug power cord Wait until lamp is sufficiently cooledLamp Hours Reset Remove the lamp coverMain unit cleaning Lens and main unit cleaningLamp replacement Lens cleaningBrightness Status displayBefore calling service personnel Specification SpecificationsList of general specifications List of supported signals RGB signals Pin assignment of Computer in terminals SpecificationsList of supported signals Hdtv signals List of supported signals Video, S-Video signalsSeparately Sold Product Pin assignment of S-Video terminal