Toshiba B-570-QQ owner manual Removing the paper holders upper plates from the media guide

Page 14

6. LOADING THE MEDIA

EM1-33035

6. LOADING THE MEDIA

■ Removing the paper holders' upper plates from the media guide

1 Remove the two T-4x8 screws to detach the media guide from the printer.

Media Guide

Screw (T-4x8)

Fig. 6-5

2Remove the SM-3x6 screw or the SM-3x8 screw to detach the paper holders' upper plates from the media guide.

(Right)	(Left)
Screw (SM-3x6)	Screw (SM-3x8)
Paper Holder	Paper Holder

Fig. 6-6

3Attach the media guide back in position.

NOTE: Do not lose the removed upper plates because they are required when using the label rolled with labels facing inside.

9.Set the black mark/feed gap sensor to the correct position by turning the adjusting knob. Turning the knob right will move the sensor towards the center of the media while turning left will move it away from the center of the media.

6-3

Image 14

Contents QQ Series Energy Star is a U.S. registered mark Safety Summary Precautions Request Regarding MaintenanceTable of Contents Applicable Model AccessoriesIntroduction 7 2 Q QOption SpecificationsPrinter Media RibbonOperation Panel OverviewFront/Rear View DIP Switch Functions Turn the Power OFF before switching the functionsCentronics Interface 36 pins, Male Installing the PrinterConnecting the Power Cord and Cables Expansion I/O Interface 24 pins, MaleLoading the Media Groove Ridge Removing the paper holders upper plates from the media guide An easy way to set the black mark sensor position Batch type Strip typeBuilt-in rewinder type Loading the Ribbon Inserting the Optional Flash Memory Card STI-FL/4ACARE/HANDLING of the Media and Ribbon General Maintenance CleaningCovers and Panels Removing Jammed PaperCleaning the Cutter Unit Threshold Setting Threshold setting procedureAuto Ribbon Saving Mode Troubleshooting Error Message Problem SolutionHead Error Restaert keyProblem Solution