Toshiba B-570-QQ owner manual Cleaning the Cutter Unit

Page 23

10. GENERAL MAINTENANCE

■Cleaning the Cutter Unit

EM1-33035

10.3 Removing Jammed Paper

WARNING!

1.Be sure to turn the power off before cleaning the cutter unit.

2.The cutters are sharp and care should be taken not to injure yourself when cleaning.

1.Loosen two screws and remove the cutter cover.

2.Remove the white screw and media guide.

3.Remove the jammed paper and trash.

4.Clean the cutter with dry cloth.

Media Guide	Fixed Cutter
Screw

White Screw (24741710304)

Cutter Cover

Cutter Unit

Swing Cutter

Fig. 10-3

5. Assembling is reverse order of removal.

10-3

Image 23

Contents QQ Series Energy Star is a U.S. registered mark Safety Summary Request Regarding Maintenance PrecautionsTable of Contents 7 2 Q Q AccessoriesIntroduction Applicable ModelOption SpecificationsPrinter Ribbon MediaOperation Panel OverviewFront/Rear View Turn the Power OFF before switching the functions DIP Switch FunctionsExpansion I/O Interface 24 pins, Male Installing the PrinterConnecting the Power Cord and Cables Centronics Interface 36 pins, MaleLoading the Media Groove Ridge Removing the paper holders upper plates from the media guide An easy way to set the black mark sensor position Strip type Batch typeBuilt-in rewinder type Loading the Ribbon STI-FL/4A Inserting the Optional Flash Memory CardCARE/HANDLING of the Media and Ribbon Cleaning General MaintenanceRemoving Jammed Paper Covers and PanelsCleaning the Cutter Unit Threshold setting procedure Threshold SettingAuto Ribbon Saving Mode Error Message Problem Solution TroubleshootingRestaert key Head ErrorProblem Solution