Toshiba B-570-QQ owner manual General Maintenance, Cleaning

Page 21

10. GENERAL MAINTENANCE

EM1-33035

10.1 Cleaning

10. GENERAL MAINTENANCE

WARNING!

1.Be careful when handling the print head as it becomes very hot.

2.Care must be taken not to injure yourself with the printer paper cutter.

3.Do not touch moving parts. To reduce the risk that fingers, jewelry, clothing, etc., be drawn into the moving parts, push the switch in the “OFF” position to stop movement.

4.To avoid injury, be careful not to catch or jam your fingers while opening or closing the cover.

10.1Cleaning

To help retain the high quality and performance of your printer it should be regularly cleaned. The greater the usage of the printer, the more frequent the cleaning. (i.e. low usage=weekly : high usage=daily).

1.Turn the power off.

2.Open the top cover.

3.Turn the head lever to raise the print head.

4.Remove the ribbon and media.

5.Clean the element of print head with print head cleaner.

6.Wipe the platen, feed roller and pinch roller with a cleaner moistened with alcohol. Remove dust or foreign substances from the internal part of the printer, if any.

Element

Pinch Roller

Print Head

Print Head

 

 

Element

Feed Roller

 

 

 

Platen

 

Print Head Cleaner

 

Fig. 10-1

(24089500013)

 

WARNING!

1.Be sure to disconnect the power cord prior ot performing any maintenance.

2.Do not use any tool that may damage the print head.

3.DO NOT POUR WATER directly onto the printer.

10-1

Image 21
Contents QQ Series Energy Star is a U.S. registered mark Safety Summary Request Regarding Maintenance PrecautionsTable of Contents Introduction AccessoriesApplicable Model 7 2 Q QSpecifications PrinterOption Ribbon MediaOverview Front/Rear ViewOperation Panel Turn the Power OFF before switching the functions DIP Switch FunctionsConnecting the Power Cord and Cables Installing the PrinterCentronics Interface 36 pins, Male Expansion I/O Interface 24 pins, MaleLoading the Media Groove Ridge Removing the paper holders upper plates from the media guide An easy way to set the black mark sensor position Strip type Batch typeBuilt-in rewinder type Loading the Ribbon STI-FL/4A Inserting the Optional Flash Memory CardCARE/HANDLING of the Media and Ribbon Cleaning General MaintenanceRemoving Jammed Paper Covers and PanelsCleaning the Cutter Unit Threshold setting procedure Threshold SettingAuto Ribbon Saving Mode Error Message Problem Solution TroubleshootingRestaert key Head ErrorProblem Solution