Toshiba B-570-QQ Installing the Printer, Connecting the Power Cord and Cables, RS-232C Interface

Page 11

5. INSTALLING THE PRINTER

EM1-33035

5.1INSTALLING THE PRINTER

5. INSTALLING THE PRINTER

Connecting the Power Cord and Cables

WARNING!

Turn the POWER SWITCH to OFF before connecting the power cord or cables.

Serial I/F Cable (RS-232C)

Expansion I/O Cable

Parallel I/F Cable (Centronics)

Power Cord

Fig. 5-1

NOTE: Only the power cord is provided with this product. If using another cable, it should conform to the following specifications. For more details, please contact your local TOSHIBA TEC service representative.

Centronics Interface (36 pins, Male)

Printer-Side Connector Pin Signals

Expansion I/O Interface (24 pins, Male)

Printer-Side Connector Pin Signals

RS-232C Interface

DB-25S (25 pins, Male,

Metric screw type)

Connector to Printer

PIN No.

Signal

1

Shield

2

RXD

3TXD

4CTS

5RTS

6DTR

7GND

20

DSR

DB-9P

Connector to PC

PIN No.

Signal

1N.C.

2RXD

3TXD

4DTR

5GND

6DSR

7RTS

8CTS

9N.C.

5-1

Image 11
Contents QQ Series Energy Star is a U.S. registered mark Safety Summary Request Regarding Maintenance PrecautionsTable of Contents 7 2 Q Q AccessoriesIntroduction Applicable ModelOption SpecificationsPrinter Ribbon MediaOperation Panel OverviewFront/Rear View Turn the Power OFF before switching the functions DIP Switch FunctionsExpansion I/O Interface 24 pins, Male Installing the PrinterConnecting the Power Cord and Cables Centronics Interface 36 pins, MaleLoading the Media Groove Ridge Removing the paper holders upper plates from the media guide An easy way to set the black mark sensor position Strip type Batch typeBuilt-in rewinder type Loading the Ribbon STI-FL/4A Inserting the Optional Flash Memory CardCARE/HANDLING of the Media and Ribbon Cleaning General MaintenanceRemoving Jammed Paper Covers and PanelsCleaning the Cutter Unit Threshold setting procedure Threshold SettingAuto Ribbon Saving Mode Error Message Problem Solution TroubleshootingRestaert key Head ErrorProblem Solution