Toshiba B-570-QQ owner manual Auto Ribbon Saving Mode

Page 25

10. GENERAL MAINTENANCE

EM1-33035

10.4 Threshold Setting

■Threshold setting procedure (For firmware version 2.5 or earlier)

1Turn the power on.

2Load the pre-printed label. (Any position)

3 Press the [PAUSE] key once.

4 Hold down the [PAUSE] key for more than 3 seconds and it will begin to feed. After it has fed the 2 label, release the [PAUSE] key.

5 Press the [RESTART] key for ON LINE mode.

6 Threshold setting is now completed.

NOTES: 1. If the [PAUSE] key is not held down for more than 3 seconds in PAUSE mode the threshold will not be set.

2.If the [PAUSE] key is released before 2 labels have been issued the setting may not be correct and will have to be re-set.

10.5Auto Ribbon Saving Mode

Auto ribbon saving function is activated when it is selected by DIP switch (Refer to page 4-1) and no print area extends more than 20 mm.

NOTE: According to the relation between the outer diameter of rewound ribbon and print speed, ribbon loss per saving varies as follows:

Print speed

Ribbon loss

3"/sec.

Approx. 5 mm

5"/sec.

Approx. 8 mm

 

 

 

 

8"/sec.

Approx. 17 mm

10-5

Page 24 Page 26
Image 25
Page 24 Page 26
Contents QQ Series Energy Star is a U.S. registered mark Safety Summary Request Regarding Maintenance PrecautionsTable of Contents Introduction AccessoriesApplicable Model 7 2 Q QPrinter SpecificationsOption Ribbon MediaFront/Rear View OverviewOperation Panel Turn the Power OFF before switching the functions DIP Switch FunctionsConnecting the Power Cord and Cables Installing the PrinterCentronics Interface 36 pins, Male Expansion I/O Interface 24 pins, MaleLoading the Media Groove Ridge Removing the paper holders upper plates from the media guide An easy way to set the black mark sensor position Strip type Batch typeBuilt-in rewinder type Loading the Ribbon STI-FL/4A Inserting the Optional Flash Memory CardCARE/HANDLING of the Media and Ribbon Cleaning General MaintenanceRemoving Jammed Paper Covers and PanelsCleaning the Cutter Unit Threshold setting procedure Threshold SettingAuto Ribbon Saving Mode Error Message Problem Solution TroubleshootingRestaert key Head ErrorProblem Solution
Top Page Image Contents