Toshiba B-443 owner manual List of Standards of Conformity

Page 2

LIST OF STANDARDS OF CONFORMITY

Manufacturer

: TOSHIBA TEC Corporation

Address

: 570 Ohito, Ohito-cho, Tagata-Gun, Shizuoka-ken, 410-2392

 

Japan

 

declares that following product

Product Name

: Bar Code Printer

Model

: B-443-QP

Options

: All

 

 

conforms to the following product specifications

Safety

: EN

60950

EMC

: EN

55022

 

EN

50082-1

Supplementary Information

The product herewith complies with the requirements of the Low Voltage Directive 73/23/ ECC, and the EMC directive 89/336/ECC.

TÜV / GS

Wichtige Sicherheitshinweise

1.Bitte lesen Sie diese Hinweise sorgfältig durch.

2.Bewahren Sie diese Anleitung für den späteren Gebrauch auf.

3.Vor dem Reinigungsvorgang ist der Drucker von Stromnetz zu trennen. Verwenden Sie keine Flüssig-oder Aerosolreiniger. Am besten eignet sich ein angefeuchtetes Tuch.

4.Die Netzsteckdose sollte nah am Drucker liegen und leicht zugänglich sein.

5.Der Drucker ist vor Feuchtigkeit zu schützen.

6.Bei der Aufstellung ist auf einen sicheren Stand der Druckers zu achten. Ein Kippen oder Fallen könnte Beschädigungen hervorrufen.

7.Beachten Sie die Anschlußwerte der Druckers beim Anschluß an das Stromnetz.

8.Diese Gerät kann bis zu einer Außentemperatur von maximal 40 oC betrieben werden.

Copyright © 1999

by TOSHIBA TEC CORPORATION All Right s Reserved

570 Ohito, Ohito-cho, Tagata-gun, Shizuoka-ken, JAPAN

Image 2
Contents 443 List of Standards of Conformity EO1-33013 Contents Options Supplies Label Stock Ribbon Safety Summary Meanings of Each SymbolPrecautions Product Introduction CompliancesUnpacking and Inspection Equipment ChecklistApplicable Model EO1-33013 Printer Parts Top front viewInterior view Rear view External Label Roll Mount External label roll mountButtons and Indicators Setting Up the Printer Loading Label and Tag StockInserting label supply roll into label roll mount Feed labels through adjustable label guide Setting up printer for self-peeling function Self-Peeling FunctionPrinter ready for self-peeling function Ribbon Loading Instructions Placement of ribbon supply roll Installation of label stock and thermal transfer ribbon Install External Label Roll Mount Installation of external label roll mountInstall Memory Module Installation of memory module OptionSelf Test Dump Mode Gap Sensor Calibration Utility Power-on UtilitiesSelf Test Utility Parameter Default Value Cleared by Initialization Printer InitializationError Messages Troubleshooting Guide Problem SolutionPower Requirements SpecificationsIndicators and Buttons PrinterPrinter Body OptionsEnvironment Ribbon SuppliesLabel Stock