Toshiba B-443 Specifications, Printer, Indicators and Buttons, Communication Interface

Page 32

EO1-33013

5. SPECIFICATIONS, OPTIONS, & SUPPLIES

5.1Specifications

5.1.1Printer

Type: Direct thermal or thermal transfer

Print speed: Selectable speeds of 1.5, 2.0 or 3.0 inches per second

Resolution: 203 DPI (8 dots per mm)

Font styles: Five alphanumeric fonts from 0.059"H (1.5 mm) to 0.23" (6.0 mm), expandable vertically and horizontally up to 8x. Smooth fonts may be downloaded from “Label Design”

Bar codes: Code 39, Code 93, Code 128 UCC, Code 128 (Subsets A, B and C), Codabar, Interleaved 2 of 5, EAN-8, EAN-13, UPC-A, UPC-E, EAN and UPC with 2 or 5 digit add-on, Postnet

2D bar codes: Maxicode, PDF-417, DataMatrix

Graphics: Mono PCX format

5.1.2 Indicators and Buttons

Indicators: PWR., ON-LINE, ERR.

Buttons: POWER, PAUSE, FEED,

Note:The functions of buttons and LEDs can be redefined by commands.

5.1.3 Communication Interface

Communications: RS-232C(DB-9) at 2400, 4800, 9600 or 19200 baud and standard Centronics interface.

Character set: ANSI ASCII character set

Word length: 7 or 8 data bits, 1 or 2 stop bits, even, odd or none parity.

Handshaking: Xon/Xoff (on receive mode only) and DSR/DTR

Input buffer: 60KB

5.1.4 Power Requirements

Input voltage: Switching power, 110-240 VAC, 50-60 Hz

Output voltage: 24 VDC

Circuit protection: 2A maximum

25

Image 32
Contents 443 List of Standards of Conformity EO1-33013 Contents Options Supplies Label Stock Ribbon Safety Summary Meanings of Each SymbolPrecautions Product Introduction CompliancesUnpacking and Inspection Equipment ChecklistApplicable Model EO1-33013 Printer Parts Top front viewInterior view Rear view External Label Roll Mount External label roll mountButtons and Indicators Setting Up the Printer Loading Label and Tag StockInserting label supply roll into label roll mount Feed labels through adjustable label guide Setting up printer for self-peeling function Self-Peeling FunctionPrinter ready for self-peeling function Ribbon Loading Instructions Placement of ribbon supply roll Installation of label stock and thermal transfer ribbon Install External Label Roll Mount Installation of external label roll mountInstall Memory Module Installation of memory module OptionSelf Test Dump Mode Gap Sensor Calibration Utility Power-on UtilitiesSelf Test Utility Parameter Default Value Cleared by Initialization Printer InitializationError Messages Troubleshooting Guide Problem SolutionSpecifications Indicators and ButtonsPower Requirements PrinterPrinter Body OptionsEnvironment Ribbon SuppliesLabel Stock