Toshiba B-443 owner manual Setting Up the Printer, Loading Label and Tag Stock

Page 16

EO1-33013

3. SET UP

3.1Setting Up the Printer

1.Place the printer on a flat, secure surface.

2.Make sure the POWER switch is off.

3.Connect the printer to the computer mainframe with the provided RS-232C or Centronics cable.

4.Plug the power cord into the power supply connector at the rear of the printer, and then plug the power cord into a properly grounded receptable.

3.2Loading Label and Tag Stock

1.Open the printer cover

2.Disengage the printer carriage by pulling the printer carriage release lever on the left side of the platen.

3.Slide the label supply roll spindle through the core of a label roll and attach the fixing tabs onto the spindle.

4.Place the label roll into the label roll mount. Feed the label under the carriage and over the platen.

5.Adjust the label guide to fit the width of the media.

6.Engage the printer carriage.

7.Wind the label roll until it becomes adequately taut.

8.Close the printer cover and press the FEED button three or four times until the green ON-LINEindicator illuminates.

9.When the printer is out of ribbon or media, the ON-LINELED will not illuminate and the ERR. LED will flash. Reload the ribbon or media without turning off the printer power. Press the FEED button three or four times until the ON-LINELED illuminates. The printing job will be resumed without data loss.

9

Page 15 Page 17
Image 16
Page 15 Page 17
Contents 443 List of Standards of Conformity EO1-33013 Contents Options Supplies Label Stock Ribbon Safety Summary Meanings of Each SymbolPrecautions Product Introduction CompliancesApplicable Model Equipment ChecklistUnpacking and Inspection EO1-33013 Printer Parts Top front viewInterior view Rear view External Label Roll Mount External label roll mountButtons and Indicators Setting Up the Printer Loading Label and Tag StockInserting label supply roll into label roll mount Feed labels through adjustable label guide Setting up printer for self-peeling function Self-Peeling FunctionPrinter ready for self-peeling function Ribbon Loading Instructions Placement of ribbon supply roll Installation of label stock and thermal transfer ribbon Install External Label Roll Mount Installation of external label roll mountInstall Memory Module Installation of memory module OptionSelf Test Dump Mode Self Test Utility Power-on UtilitiesGap Sensor Calibration Utility Parameter Default Value Cleared by Initialization Printer InitializationError Messages Troubleshooting Guide Problem SolutionSpecifications Indicators and ButtonsPower Requirements PrinterEnvironment OptionsPrinter Body Label Stock SuppliesRibbon
Top Page Image Contents