Diagnostics over Industrial Ethernet
6.3.9Trap Configuration
Clicking the Trap Config menu opens the window shown in Figure
Figure 6-15 Trap Configuration Window
If an alarm occurs, the ELS can send traps (alarm messages) to up to two different (network management) stations at the same time. In this menu, you enter the addresses of the stations to which the traps will be sent. The corresponding events must also be activated in the "Event Configuration Menu".
●Trap Address x
Enter the IP addresses of the stations to which traps will be sent (range per field: 0 to 255).
●Get Current Values/Set New Values
If you click the "Get Current Values" button, you obtain the values currently stored on the ELS. To save the entries made in this window, click the "Set New Values" button.
Industrial Ethernet | 67 |