Toshiba B-EV4T SERIES, EO1-33087 owner manual Connecting the Power Adapter and the Power Cord

Page 16

2. PRINTER SETUP

ENGLISH VERSION EO1-33087

2.5 Connecting the Power Adapter and the Power Cord

2.5Connecting the Power Adapter and the Power Cord

NOTES:

1.Since the power cord is not enclosed in this printer, please purchase a proper one after referring to page 1-2.

2.The EA10953 AC adapter should be exclusively used for the B-EV4T Series printer. The B-EV4T Series printer must be powered by the EA10953 AC adapter.

1.Make sure that the printer power switch is in the OFF (O) position.

2.Insert the Power Cord into the inlet of the Power Adapter.

Power Adapter

Power Cord

3.Insert the Power Adapter connector into the Power Jack on the rear of the printer.

Power Jack

Power Adapter

Connector

E2- 5

Image 16

Contents EV4T Series CE Compliance for EU only VorsichtSafety Summary Meanings of Each SymbolPrecautions Request Regarding MaintenanceTable of Contents EA2-1 GlossariesIntroduction Features Unpacking Accessories Product OverviewWhen purchasing the power cord SVT H05VV-FFront View DimensionsRear View Interior Button and Indicator Lamp Printer statusPrinter Setup PrecautionsTurning the Printer Procedure before OperationTurning on the Printer Turning OFF the Printer Connecting the Cables to the Printer Connecting the Power Adapter and the Power Cord To open the Top Cover Opening/Closing the Top CoverTo close the Top Cover Loading the Media Open the Media Holders 1 Media Sensor Calibration Batch mode Strip mode Option How to set the mediaHow to Load Fanfold Paper Stock Cut mode OptionExternal Media Roll Hanger Option Loading the Ribbon BrokenPrint Head Block Ribbon Access Cover Close the Ribbon Access Cover until it clicks Media Sensor Test, and Dump Mode different type UtilitiesMedia Sensor Calibration Self Print Test and Dump Mode Print test label sampleE2-19 „ Inserting an SD Card How to Use an SD Card„ Removing an SD Card Cleaning MaintenancePrint Head Platen/Sensors Media HousingCover Care/Handling of the Media and Ribbon OptionTroubleshooting Troubleshooting GuideColor Status Cause Solutions Status LampRemoving Jammed Media Appendix 1 Specifications A1.1 PrinterEV4T-TS14-QM-R A1.2 Options A1.3 MediaA1.3.1 Media Type LabelA1.3.2 Detection Area of the Transmissive Sensor A1.3.3 Detection Area of the Reflective Sensor A1.3.4 Effective Print AreaA1.4 Ribbon Figure below shows the effective print area on the mediaAppendix 2 Interface Interface CablesGlossaries Bar codeSupply Page EO1-33087