Toshiba B-EV4T SERIES, EO1-33087 owner manual Strip mode Option, How to set the media

2. PRINTER SETUP

ENGLISH VERSION EO1-33087

2.7 Loading the Media

2.7Loading the Media (Cont.)

NOTES:

1.When issuing labels without removing them from the backing paper, it is not necessary to pass the media through the Strip Block.

2.When the media is correctly set, the backing paper is supposed to be pinched by the Platen and the Strip Feed Roller as shown below.

Strip Plate

Label

Strip Feed Roller

Platen

Backing Paper

3.If the peel-off issue is performed under intense light, the strip sensor may not correctly detect the presence of a printed label on the strip shaft. In this case, reduce the intensity of the light or fit the Shade Plate to the Strip Block as shown in the figure.

Strip mode (Option):

When issued in the strip mode, labels are automatically removed from the backing paper each time a label is printed.

•How to set the media

When issuing labels in the strip mode, set the label in the following procedure:

1.Load the media as described on the previous pages.

2.Open the Strip Block by pulling it out.

Strip Block

3.Remove enough labels from the leading edge of the media to leave 20 cm of backing paper free, and insert the top edge of the backing paper into the media slot in the Strip Block.

Shade Plate

4.Close the Strip Block and Top Cover.

E2-11