Toshiba EO1-33087, B-EV4T SERIES owner manual Open the Media Holders

Page 19

2. PRINTER SETUP

ENGLISH VERSION EO1-33087

2.7 Loading the Media

2.7Loading the Media (Cont.)

2.Slide the Media Holder Lock Switch to the Unlock (▲) side to release the Media Holders.

Media Holder Lock Switch

NOTE: Media path

Feed Gap Sensor

Platen

Black mark sensor

NOTES:

1.Refer to the Supply Path Label attached inside of the Top Cover.

2.Make sure that the print side faces up.

3.Cut the leading edge of the media straight with scissors.

NOTE:

Do not forcibly move the Media Guides by hand, as doing so may break the Media Guides.

3.Open the Media Holders.

Media Holder

Media Holder

4.Place a media roll between the Media Holders so that the media is fed with the print side facing up. Fit the projection of the Media Holders into the core. Make sure that the projection of the both Media Holders is engaged with the core firmly.

Media

Media Holder

Media Holder

5.Turn the Media Guide Adjustment Dial in the arrow indicating direction to move the Media Guides outward.

Media Guide

Adjustment Dial

E2- 8

Image 19
Contents EV4T Series Vorsicht CE Compliance for EU onlyMeanings of Each Symbol Safety SummaryRequest Regarding Maintenance PrecautionsTable of Contents Glossaries EA2-1Product Overview Introduction Features Unpacking AccessoriesSVT H05VV-F When purchasing the power cordFront View DimensionsRear View Interior Printer status Button and Indicator LampPrecautions Printer SetupTurning the Printer Procedure before OperationTurning on the Printer Turning OFF the Printer Connecting the Cables to the Printer Connecting the Power Adapter and the Power Cord To open the Top Cover Opening/Closing the Top CoverTo close the Top Cover Loading the Media Open the Media Holders 1 Media Sensor Calibration Batch mode How to set the media Strip mode OptionCut mode Option How to Load Fanfold Paper StockExternal Media Roll Hanger Option Broken Loading the RibbonPrint Head Block Ribbon Access Cover Close the Ribbon Access Cover until it clicks Media Sensor Test, and Dump Mode different type UtilitiesMedia Sensor Calibration Print test label sample Self Print Test and Dump ModeE2-19 „ Inserting an SD Card How to Use an SD Card„ Removing an SD Card Cleaning MaintenancePrint Head Platen/Sensors Media HousingCover Option Care/Handling of the Media and RibbonTroubleshooting Guide TroubleshootingStatus Lamp Color Status Cause SolutionsRemoving Jammed Media A1.1 Printer Appendix 1 SpecificationsEV4T-TS14-QM-R Label A1.2 OptionsA1.3 Media A1.3.1 Media TypeA1.3.2 Detection Area of the Transmissive Sensor A1.3.4 Effective Print Area A1.3.3 Detection Area of the Reflective SensorFigure below shows the effective print area on the media A1.4 RibbonInterface Cables Appendix 2 InterfaceBar code GlossariesSupply Page EO1-33087