Toshiba EO1-33087, B-EV4T SERIES owner manual Removing Jammed Media

Page 37

4. TROUBLESHOOTING

ENGLISH VERSION EO1-33087

4.3 Removing Jammed Media

Flashing speed of the LED

Status	Flashing interval
Flashing slowly	1 sec.
Flashing at medium speed	0.5 sec.
Flashing fast	0.2 sec.

4.3 Removing Jammed Media

This section describes in detail how to remove jammed media from the printer.

CAUTION!

Do not use any tool that may damage the print head.

1.Turn the power off.

2.Open the Top Cover and remove the media roll.

3.Open the Ribbon Access Cover and remove the ribbon.

4.Remove the jammed media from the printer. DO NOT USE any sharp implements or tools as these could damage the printer.

5.Clean the Print Head and Platen, then remove any further dust or foreign substances.

6.Load the media and ribbon again, and close the Ribbon Access Cover and the Top Cover.

E4- 3

Image 37

Contents EV4T Series Vorsicht CE Compliance for EU onlyMeanings of Each Symbol Safety SummaryRequest Regarding Maintenance PrecautionsTable of Contents Glossaries EA2-1Product Overview Introduction Features Unpacking AccessoriesSVT H05VV-F When purchasing the power cordFront View DimensionsRear View Interior Printer status Button and Indicator LampPrecautions Printer SetupTurning the Printer Procedure before OperationTurning on the Printer Turning OFF the Printer Connecting the Cables to the Printer Connecting the Power Adapter and the Power Cord To open the Top Cover Opening/Closing the Top CoverTo close the Top Cover Loading the Media Open the Media Holders 1 Media Sensor Calibration Batch mode How to set the media Strip mode OptionCut mode Option How to Load Fanfold Paper StockExternal Media Roll Hanger Option Broken Loading the RibbonPrint Head Block Ribbon Access Cover Close the Ribbon Access Cover until it clicks Media Sensor Test, and Dump Mode different type UtilitiesMedia Sensor Calibration Print test label sample Self Print Test and Dump ModeE2-19 „ Inserting an SD Card How to Use an SD Card„ Removing an SD Card Cleaning MaintenancePrint Head Platen/Sensors Media HousingCover Option Care/Handling of the Media and RibbonTroubleshooting Guide TroubleshootingStatus Lamp Color Status Cause SolutionsRemoving Jammed Media A1.1 Printer Appendix 1 SpecificationsEV4T-TS14-QM-R A1.3 Media A1.2 OptionsA1.3.1 Media Type LabelA1.3.2 Detection Area of the Transmissive Sensor A1.3.4 Effective Print Area A1.3.3 Detection Area of the Reflective SensorFigure below shows the effective print area on the media A1.4 RibbonInterface Cables Appendix 2 InterfaceBar code GlossariesSupply Page EO1-33087