Toshiba EO1-33087 How to Use an SD Card, Inserting an SD Card, Removing an SD Card

Page 31

2. PRINTER SETUP

ENGLISH VERSION EO1-33087

2.10 How to Use an SD Card

2.10How to Use an SD Card

CAUTION!

1.Turn off the printer before inserting or removing an SD card. Failure to do this may destroy the data in the SD card.

2.Do not turn off the printer during access to the SD card, as doing so may destroy the data in the SD card.

3.For handling of the SD card, refer to the instruction supplied with the SD card.

This printer enables you to save print formats, writable characters, True Type fonts, etc. in commercially available SD cards.

For available SD card types, please ask the nearest TOSHIBA TEC representative.

For how to save data in an SD card, please refer to the External Equipment Interface Specification stored in the CD-ROM.

Inserting an SD Card

1.Turn off the printer and open the SD card slot cover.

2.Hold an SD card with the print surface facing up, and insert it into the SD card slot until it clicks.

SD Card Slot

Cover

SD Card

3.Close the SD card slot cover.

Removing an SD Card

1.Confirm no access is made to the SD card, and turn off the printer.

2.Open the SD card slot cover.

3.Push the SD card. The SD card pops up.

4.Remove it from the slot, and close the SD card slot cover.

E2-20

Image 31

Contents EV4T Series Vorsicht CE Compliance for EU onlyMeanings of Each Symbol Safety SummaryRequest Regarding Maintenance PrecautionsTable of Contents Glossaries EA2-1Product Overview Introduction Features Unpacking AccessoriesSVT H05VV-F When purchasing the power cordFront View DimensionsRear View Interior Printer status Button and Indicator LampPrecautions Printer SetupTurning the Printer Procedure before OperationTurning on the Printer Turning OFF the Printer Connecting the Cables to the Printer Connecting the Power Adapter and the Power Cord To open the Top Cover Opening/Closing the Top CoverTo close the Top Cover Loading the Media Open the Media Holders 1 Media Sensor Calibration Batch mode How to set the media Strip mode OptionCut mode Option How to Load Fanfold Paper StockExternal Media Roll Hanger Option Broken Loading the RibbonPrint Head Block Ribbon Access Cover Close the Ribbon Access Cover until it clicks Media Sensor Test, and Dump Mode different type UtilitiesMedia Sensor Calibration Print test label sample Self Print Test and Dump ModeE2-19 „ Inserting an SD Card How to Use an SD Card„ Removing an SD Card Cleaning MaintenancePrint Head Platen/Sensors Media HousingCover Option Care/Handling of the Media and RibbonTroubleshooting Guide TroubleshootingStatus Lamp Color Status Cause SolutionsRemoving Jammed Media A1.1 Printer Appendix 1 SpecificationsEV4T-TS14-QM-R Label A1.2 OptionsA1.3 Media A1.3.1 Media TypeA1.3.2 Detection Area of the Transmissive Sensor A1.3.4 Effective Print Area A1.3.3 Detection Area of the Reflective SensorFigure below shows the effective print area on the media A1.4 RibbonInterface Cables Appendix 2 InterfaceBar code GlossariesSupply Page EO1-33087