Installing onto Windows 98/Me/2000 (USB interface)
Before starting the installation, make sure the USB interface cable is not connected to the MFP.
1 Insert the supplied
2 
), and then 
) icon.
When any of “Hardware Found”, or “Found New Hardware Wizard” messages appear during the software installation, be sure to click the “Cancel” button.
3 Double-click the “setup” (
) icon.
If the language selection screen appears after you double click the “setup” icon, select the language you wish to use and click the “Next” button. (Normally, the correct language is selected automatically.)
4 Select the software packages to be installed, and then click the “Next” button.
The software packages with checkmark ( 
) on the list on the screen will be installed. Click the “Display README” button to show the information on the selected package.
If the following screen appears, click the “OK” button. Review the contents in “BEFORE INSTALLATION” (See p.
5 Review the software packages to be installed on the screen, and then click the “Start” button. The software packages to be installed will be displayed on the screen. If inappropriate packages are displayed, click the “Back” button to select appropriate packages again.