Installing AN External CD-ROM

(TXM6401F1)

The instructions that follow are for use on PC and Macintosh systems.

In order to install your external CD-ROM successfully, you will need to complete the following steps.

☛Install SCSI host adapter board in your computer system (if not already installed). - PC systems only

☛Set SCSI ID Switch on CD-ROM.

☛Using a SCSI cable, connect CD-ROM to SCSI interface card or SCSI port.

☛Connect supplied power cord to CD-ROM.

☛Load CD-ROM driver software.

IMPORTANT NOTE

Before you begin installing your CD-ROM, make sure your computer is switched OFF and the power cable is disconnected.

CD-ROM SCSI ID SETTING

In order for your CD-ROM to work properly, it may be necessary for you to change the CD-ROM’s SCSI ID. All SCSI devices attached to your computer are assigned a SCSI ID number from 0 to 7. Your CD- ROM’s SCSI ID must be set so that its ID number does not conflict with any other SCSI device’s ID in your system. In most cases your CD-ROM system will come set to SCSI ID 0. If your CD-ROM is the only SCSI device connected to your computer, you should leave the SCSI ID switch in the default position. If you have additional SCSI devices (another CD-ROM, hard drive, etc.) you will be “daisy-chain- ing” these devices. Each SCSI device must have a different SCSI ID. Note that your SCSI interface card, in most cases, has a SCSI ID of 7.

The SCSI ID Switch is located on the rear of the CD-ROM Enclo- sure. Click button to select a SCSI ID between 0 and 7.

12TOSHIBA XM-6401B/TXM6401F1 CD-ROM Drive