Toshiba (T)XM6401B/F1 Front Panel, Busy light remains ON. The CD-ROM is accessing data

Page 22

THE FRONT PANEL

Eject Button - The EJECT button is used to open the disc tray so you can install or remove a disc. The EJECT Inhibit Jumper must be set to OFF in order for the EJECT button to function. (If jumper is in ON postion, the drive accepts all eject control from the computer).

Busy Light - When you install a disc into the CD-ROM drive, the BUSY light flashes slowly as it attempts to locate the disc. One of the following will occur:

•BUSY light goes out. The CD-ROM drive is ready to read data from the disc.

•BUSY light flashes slowly. The disc may be dirty.

•BUSY light remains ON. The CD-ROM is accessing data.

•BUSY light remains ON indefinitely. The CD-ROM is experienc- ing an error.

Headphone Jack - The headphone jack is used to connect headphones to your CD-ROM.

Emergency Eject Hole - The emergency eject hole is to be used only when the CD tray will not open when EJECT button is pressed. See page 20 for additional information.

Volume Control - The volume control is used to adjust the level of the audio signal from the headphone jack. The volume control does not affect the level of the signal sent to the audio output on the back of the drive.

TOSHIBA XM-6401B/TXM6401F1 CD-ROM Drive 17

Page 21 Page 23
Image 22
Page 21 Page 23
Contents CD-ROM Drive CD-ROM Drive This equipment complies with the following standards Version DatePublished RevisedContents Trademark InformationTable of Contents Introduction XM-6401B Front PanelScsi Drives Installing CD-ROM Installation RequirementsCD-ROM Jumper Settings Jumper LocationParity Jumper Eject Prevention Jumper Power Supply Jumper Termination Power JumperTerminator ON/OFF Jumper Test/Audio Reproduction JumperInstalling XM-6401B Placing CD-ROM Inside Your ComputerCabling Installing Power CableAttaching Scsi Cable Installing Sound Cable TXM6401F1/XM-6401B Connection ONE Drive Mounting CD-ROM Completing InstallationSoftware Installing AN External CD-ROM CD-ROM Scsi ID SettingTermination Scsi ID SwitchExternal Terminator Scsi Cabling and Power Connector Software Using your CD-ROM ControlsBusy light remains ON. The CD-ROM is accessing data Front PanelBack Panel XM-6401B Back Panel TXM6401F1 Back PanelScsi ID Switch Selects Scsi ID TXM6401F1 only Operating the CD Loading Tray Vertical InstallationsCD Loading Tray Emergency Eject Inserting Bar to Eject CD TraySpecifications PerformanceData buffer Kbytes Load/Eject Environmental Conditions ReliabilityPhysical Characteristics FrontTechnical Support Repair Center Warranty Toshiba XM-6401B/TXM6401F1 CD-ROM Drive 470073-B0
Top Page Image Contents