Toshiba (T)XM6401B/F1 instruction manual CD-ROM Jumper Settings, Jumper Location

IMPORTANT NOTE

Before you begin installing your CD-ROM, make sure your computer is switched OFF and the power cable is disconnected.

CD-ROM JUMPER SETTINGS

In order for your CD-ROM to work properly, it may be necessary for you to change the CD-ROM’s jumper settings.

Locate the block of jumpers on the back left side of the CD-ROM.

Jumper Location

Jumpers can be set in either an ON mode or OFF mode. If the jumper covers both pins on the jumper block, it is ON, if there is no jumper or only one of the pins is jumpered, the jumper is OFF. This section will discuss the following jumper settings: SCSI ID, Parity, Eject, Test/ Audio Reproduction, Termination, and Power Supply.

SCSI-ID 0 no jumpers on ID1, 2 or 4

Spare

Jumper

Plug

PRTY ID4 ID2 ID1 TERM ON/OFF POWER TEST PRV/ALW

4TOSHIBA XM-6401B/TXM6401F1 CD-ROM Drive