Toshiba (T)XM6401B/F1 instruction manual Scsi ID Switch, Termination, External Terminator

Page 18

SCSI ID Switch

TERMINATION

If the CD-ROM is being installed as the last drive in a daisy-chain or as the only SCSI device, you must install an external terminator on one of the SCSI connectors at the rear of the CD-ROM.

External Terminator

TOSHIBA XM-6401B/TXM6401F1 CD-ROM Drive 13

Image 18

Contents CD-ROM Drive CD-ROM Drive This equipment complies with the following standards Version DatePublished RevisedContents Trademark InformationTable of Contents Introduction XM-6401B Front PanelScsi Drives Installing CD-ROM Installation RequirementsCD-ROM Jumper Settings Jumper LocationParity Jumper Eject Prevention Jumper Power Supply Jumper Termination Power JumperTerminator ON/OFF Jumper Test/Audio Reproduction JumperInstalling XM-6401B Placing CD-ROM Inside Your ComputerInstalling Power Cable CablingAttaching Scsi Cable Installing Sound Cable TXM6401F1/XM-6401B Connection ONE Drive Completing Installation Mounting CD-ROMSoftware Installing AN External CD-ROM CD-ROM Scsi ID SettingScsi ID Switch TerminationExternal Terminator Scsi Cabling and Power Connector Software Using your CD-ROM ControlsBusy light remains ON. The CD-ROM is accessing data Front PanelBack Panel XM-6401B Back Panel TXM6401F1 Back PanelScsi ID Switch Selects Scsi ID TXM6401F1 only Vertical Installations Operating the CD Loading TrayCD Loading Tray Emergency Eject Inserting Bar to Eject CD TraySpecifications PerformanceData buffer Kbytes Load/Eject Environmental Conditions ReliabilityPhysical Characteristics FrontTechnical Support Repair Center Warranty Toshiba XM-6401B/TXM6401F1 CD-ROM Drive 470073-B0