Installing CD-ROM

Before you begin to install your CD-ROM, make sure you have the items listed below. In most cases, these items will not come with your CD-ROM. See your local computer re-

tailer to purchase them.

INSTALLATION REQUIREMENTS

❑CD-ROM Software Driver (when installing on a PC the software driver must be written for the SCSI host adapter card you have installed in your computer system)

❑SCSI Host Adapter Board (PC systems only)

❑SCSI Interface Cable

❑External Terminator (TXM6401F1 installations only)

❑Power Cord (TXM6401F1 installations only)

INSTALLING AN INTERNAL CD-ROM (XM-6401B)

The instructions that follow are for use on PC systems only. In order to install your internal CD-ROM successfully, you will need to com- plete the following steps:

☛Install SCSI host adapter board in your computer system (if not already installed).

☛Set jumper settings on CD-ROM.

☛Install CD-ROM inside your computer.

☛Using a SCSI cable, connect CD-ROM to SCSI interface card.

☛Connect +5/+12V power cable to internal CD-ROM drive.

☛Connect a sound cable to your CD-ROM (optional).

☛Load CD-ROM driver software (driver is obtained from your SCSI host adapter manufacturer).

TOSHIBA XM-6401B/TXM6401F1 CD-ROM Drive