NETGEAR WPNT834 manual Trademarks, Statement of Conditions, EN 55 022 Declaration of Conformance

Page 2

© 2005 by NETGEAR, Inc. All rights reserved. November 2005.

Trademarks

NETGEAR is a trademark of Netgear, Inc.

Microsoft, Windows, and Windows NT are registered trademarks of Microsoft Corporation.

Other brand and product names are registered trademarks or trademarks of their respective holders.

Statement of Conditions

In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the products described in this document without notice.

NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.

Maximum Wireless Signal Rate Derived from IEEE Standard 802.11 Specifications

Actual data throughput will vary. Network conditions and environmental factors, including volume of network traffic, building materials and construction, and network overhead, lower actual data throughput rate.

Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

EN 55 022 Declaration of Conformance

This is to certify that the RangeMax 240 Wireless Router WPNT834 is shielded against the generation of radio interference in accordance with the application of Council Directive 89/336/EEC, Article 4a. Conformity is declared by the application of EN 55 022 Class B (CISPR 22).

Bestätigung des Herstellers/Importeurs

Es wird hiermit bestätigt, daß das RangeMax 240 Wireless Router WPNT834 gemäß der im BMPT-AmtsblVfg 243/ 1991 und Vfg 46/1992 aufgeführten Bestimmungen entstört ist. Das vorschriftsmäßige Betreiben einiger Geräte (z.B. Testsender) kann jedoch gewissen Beschränkungen unterliegen. Lesen Sie dazu bitte die Anmerkungen in der Betriebsanleitung.

Das Bundesamt für Zulassungen in der Telekommunikation wurde davon unterrichtet, daß dieses Gerät auf den Markt gebracht wurde und es ist berechtigt, die Serie auf die Erfüllung der Vorschriften hin zu überprüfen.

ii

v1.0, November 2005

Image 2
Contents NETGEAR, Inc EN 55 022 Declaration of Conformance TrademarksStatement of Conditions Bestätigung des Herstellers/ImporteursCustomer Support Certificate of the Manufacturer/ImporterVoluntary Control Council for Interference Vcci Statement World Wide WebV1.0, November Contents Chapter Wireless Configuration Chapter Troubleshooting Viii Typographical Conventions Chapter About This ManualAudience, Scope, Conventions, and Formats Manual Scope How to Use This ManualHow to Print this Manual Printing the Full Manual V1.0, November Key Features Chapter Introduction802.11g Wireless Networking RangeMax Multi-In, Multi-Out Mimo TechnologyPowerful, True Firewall with Content Filtering SecurityAutosensing Ethernet Connections with Auto Uplink Extensive Protocol SupportEasy Installation and Management Maintenance and SupportPackage Contents Netgear Related ProductsRouter’s Front Panel Status Light DescriptionsRouter’s Rear Panel Road Map for ‘How to Get There From Here’ Road Map for How to Get There From HereConnection A Road Map for How to Get There From Here Printers in aV1.0, November Chapter Connecting the Router to the Internet Prepare to Install Your Wireless RouterFirst, Use the Smart Wizard to Configure the Wireless Router Now, Set Up a Computer for Wireless Connectivity Troubleshooting Tips Overview of How to Access the Wireless Router Ways to access the routerV1.0, November V1.0, November How to Bypass the Configuration Assistant How to Manually Configure Your Internet Connection ISP Does Not Require LoginV1.0, November V1.0, November Using the Smart Setup Wizard Netgear Product Registration, Support, and Documentation V1.0, November Chapter Wireless Configuration Observing Performance, Placement, and Range GuidelinesImplementing Appropriate Wireless Security Understanding Wireless Settings V1.0, November Basic Wireless Security Options WEPV1.0, November If WPA-PSK or WPA2-PSK Authentication is Used Default Factory Settings How to Set Up and Test Basic Wireless ConnectivityV1.0, November How to Configure WEP V1.0, November How to Configure WPA-PSK or WPA2-PSK Wireless Security How to Restrict Wireless Access by MAC Address Click the Turn Access Control On check boxV1.0, November V1.0, November Chapter Content Filtering Content Filtering OverviewBlocking Access to Internet Sites Blocking Access to Internet Services Configuring a User Defined Service Scheduling When Blocking Will Be Enforced Blocking Services by IP Address RangeViewing Logs of Web Access or Attempted Web Access Log entry descriptionsConfiguring E-Mail Alert and Web Access Log Notifications Log action buttonsV1.0, November Chapter Maintenance Viewing Wireless Router Status InformationWireless Router Status Fields This screen shows the following parametersWireless port of the router. The default is Netgear Region Connection Status ItemsRouter Statistics Items Configuration File Management Viewing a List of Attached DevicesBacking Up and Restoring the Configuration Erasing the ConfigurationUpgrading the Router Software V1.0, November Changing the Administrator Password V1.0, November Basic Functioning Chapter TroubleshootingPower Light Not On Lights Never Turn Off LAN or WAN Port Lights Not OnTroubleshooting the Web Configuration Interface Troubleshooting the ISP Connection Troubleshooting a TCP/IP Network Using a Ping Utility Testing the LAN Path to Your RouterTesting the Path from Your Computer to a Remote Device Restoring the Default Configuration and Password Problems with Date and Time Advanced Configuration of the Router Configuring Advanced Wireless SettingsV1.0, November Wireless Card Access List Wireless Card Access Setup Configuring Port Triggering and Port Forwarding V1.0, November Click Add Service Configuring Port Forwarding to Local Servers Adding a Custom Service Click the Add Custom Service buttonMultiple Computers for Internet Gaming Editing or Deleting a Port Forwarding EntryLocal Web and FTP Server Example Configuring the WAN Setup Options Connecting Automatically, as RequiredResponding to a Ping on the Internet WAN Port Setting Up a Default DMZ ServerDisabling the SPI Firewall Using the LAN IP Setup Options Setting the MTU SizeConfiguring LAN TCP/IP Setup Parameters Using the Router as a Dhcp server Using Address ReservationUsing a Dynamic DNS Service Select the Use a Dynamic DNS Service check box Configuring Static Routes V1.0, November Enabling Remote Management Access Select the Turn Remote Management On check boxV1.0, November Using Universal Plug and Play UPnP V1.0, November V1.0, November Appendix a Technical Specifications Power AdapterPSK Appendix B Related Documents Document LinkV1.0, November
Related manuals
Manual 6 pages 35.94 Kb