NETGEAR manual WAB102 Wireless Access Point Rear Panel, Restore to Factory Default Button

Page 10

User’s Guide for the WAB102 802.11a+b Dual Band Wireless Access Point

WAB102 Wireless Access Point Rear Panel

Power	Restore to	Ethernet	Power
Socket	Factory Default	Port	Adapter
	Switch		Cable
			Holder

Power Socket

This socket connects to the WAB102 power adapter.

Warning: Use only the power adapter that came with the WAB102.

Restore to Factory Default Button

The Restore to Default button located between the Ethernet RJ-45 connector and the Power socket restores the WAB102 to the factory default settings.

RJ-45 Ethernet Port

Use the WAB102 Ethernet RJ-45 port to connect to and Ethernet LAN through a device such as a hub, switch, or router.

Power Adapter Cable Holder

Use the enclosed screw and wire saddle to secure the power cable.

Introduction

7

Image 10

Contents NETGEAR, Inc Technical Support Contents About the Wireless Access Point Chapter IntroductionFeatures BenefitsSystem Requirements WAB102 Dual BandWhat’s In the Box? Compatible and Related Netgear Products802.11a+b Standards-based Wireless Networking Hardware DescriptionWAB102 Wireless Access Point Front Panel Following table explains the LED indicatorsWAB102 Wireless Access Point Rear Panel Restore to Factory Default ButtonSetting Up Basic Wireless Connectivity Placement and Range Guidelines What You Will Need Before You BeginInstall the WAB102 Wireless Access Point Installation OverviewCabling Requirements Wireless Verify the installation was successful Disabled Default Factory SettingsAuthentication Type Open System Basic Configuration Determine the name of your access pointLog In to the Access Point Configure Basic Setup ParametersFor LAN parameters, see TCP/IP Configuration Parameters on Default Enable Default gatewayDefault IP AddressTurbo Mode Ssid Service Set IDDefault Wireless Default Disable802.11b Wireless LAN Configuration Parameters Change Password Security Configuration For 64-bits encryption Default key size 64 bits Authentication TypeDefault Key Key Size802.11b Wireless LAN Security Parameters Key 1Access Control Access Control List Firmware UpgradeAccess Control MAC AddressAdvanced Setup Beacon Interval Transmit PowerDefault100% RTS ThresholdDefault Long Preamble TypeRestore Factory Default AP Status Station List About Setting Up Basic Wireless Connectivity Protecting Your Wireless Network Enabling Basic Wireless Access Security FeaturesSecure the Access Point Change the PasswordBefore You Change the Ssid and WEP Settings Authentication Change the Ssid Configure WEP Encryption Restrict Wireless Activity by MAC Address Protecting Your Wireless Network No lights are lit on the access point Basic FunctioningOne or both of the wireless activity lights do not light up Ethernet Link/Act light is not litTroubleshooting Compliance Regulatory Compliance Information NETGEAR, Inc