
User’s Guide for the WAB102 802.11a+b Dual Band Wireless Access Point
Default Factory Settings
When you first receive your WAB102, the default factory settings will automatically be set, as shown below.
You can restore these defaults with the Factory Default Restore switch on the rear panel — see “WAB102 Wireless Access Point Rear Panel“ on page 7.
After you install the WAB102 dual band AP, you may customize any of the settings to better meet your networking needs — see the following section, “Basic Configuration“ on page 14.
FEATURE | DEFAULT FACTORY SETTINGS |
|
|
User Name | admin |
|
|
Password | 1234 |
|
|
Access Point Name | netgearxxxxxx where xxxxxx are the last |
| six digits of the AP's MAC address |
AP IP Address | 192.168.0.226 |
|
|
AP Subnet Mask | 255.255.255.0 |
|
|
SSID for both 802.11a & | Wireless |
802.11b |
|
11a RF Channel | 52 |
|
|
11b RF Channel | 6 |
|
|
WEP | Disabled |
|
|
Authentication Type | Open System |
|
|
Setting Up Basic Wireless Connectivity | 13 |