NETGEAR WAB102 manual Change Password

Page 23

User’s Guide for the WAB102 802.11a+b Dual Band Wireless Access Point

Change Password

1.To change the current password, choose the Password option from the AP Setup menu in the WAB102 Web Server home page. The default password is "1234."

2.Change your password. Click Apply for the new password to take effect.

Note: Take note of your new password, otherwise you will not be able to access the Access Point setup. You can restore the default password "1234" by pressing the Restore Factory Default button on the WAB102 back panel for at least 5 seconds.

20	Setting Up Basic Wireless Connectivity

Image 23

Contents NETGEAR, Inc Technical Support Contents Chapter Introduction About the Wireless Access PointBenefits FeaturesWAB102 Dual Band System RequirementsCompatible and Related Netgear Products What’s In the Box?Hardware Description 802.11a+b Standards-based Wireless NetworkingFollowing table explains the LED indicators WAB102 Wireless Access Point Front PanelRestore to Factory Default Button WAB102 Wireless Access Point Rear PanelSetting Up Basic Wireless Connectivity What You Will Need Before You Begin Placement and Range GuidelinesCabling Requirements Installation OverviewInstall the WAB102 Wireless Access Point Wireless Verify the installation was successful Authentication Type Open System Default Factory SettingsDisabled Determine the name of your access point Basic ConfigurationConfigure Basic Setup Parameters Log In to the Access PointFor LAN parameters, see TCP/IP Configuration Parameters on IP Address Default gatewayDefault Default EnableDefault Disable Ssid Service Set IDDefault Wireless Turbo Mode802.11b Wireless LAN Configuration Parameters Change Password Security Configuration For 64-bits encryption Key Size Authentication TypeDefault Key Default key size 64 bitsKey 1 802.11b Wireless LAN Security ParametersAccess Control MAC Address Firmware UpgradeAccess Control Access Control ListAdvanced Setup RTS Threshold Transmit PowerDefault100% Beacon IntervalPreamble Type Default LongRestore Factory Default AP Status Station List About Setting Up Basic Wireless Connectivity Enabling Basic Wireless Access Security Features Protecting Your Wireless NetworkBefore You Change the Ssid and WEP Settings Change the PasswordSecure the Access Point Authentication Change the Ssid Configure WEP Encryption Restrict Wireless Activity by MAC Address Protecting Your Wireless Network Basic Functioning No lights are lit on the access pointEthernet Link/Act light is not lit One or both of the wireless activity lights do not light upTroubleshooting Compliance Regulatory Compliance Information NETGEAR, Inc