NETGEAR WAB102 manual Authentication Type, Default Key, Key Size, Default key size 64 bits

Page 26

User’s Guide for the WAB102 802.11a+b Dual Band Wireless Access Point

802.11a Wireless LAN Security Parameters

CONFIGURATION

DESCRIPTION

 

 

Authentication Type

Specifies the Authentication type used: Open

 

System or Shared Key. If "Shared Key" is

 

selected, you need to enable the WEP and

 

enter at least one shared key.

 

Default: Open System

 

 

WEP

Enable or Disable the Wired Equivalent Privacy.

 

Default: Disable

 

 

Default Key

Specifies the preferred key entry from 1 to 4.

 

Default: 1

 

 

Key Size

Specifies the WEP Encryption Key size: 64 bits,

 

128 bits or 152 bits.

 

 

Key (1-4)

Specifies the shared key value in hexadecimal

 

format based on the key size selected: 64 bits,

 

128 bits, or 152 bits.

 

Default key size: 64 bits

 

 

Setting Up Basic Wireless Connectivity

23

Image 26
Contents NETGEAR, Inc Technical Support Contents About the Wireless Access Point Chapter IntroductionFeatures BenefitsSystem Requirements WAB102 Dual BandWhat’s In the Box? Compatible and Related Netgear Products802.11a+b Standards-based Wireless Networking Hardware DescriptionWAB102 Wireless Access Point Front Panel Following table explains the LED indicatorsWAB102 Wireless Access Point Rear Panel Restore to Factory Default ButtonSetting Up Basic Wireless Connectivity Placement and Range Guidelines What You Will Need Before You BeginCabling Requirements Installation OverviewInstall the WAB102 Wireless Access Point Wireless Verify the installation was successful Authentication Type Open System Default Factory SettingsDisabled Basic Configuration Determine the name of your access pointLog In to the Access Point Configure Basic Setup ParametersFor LAN parameters, see TCP/IP Configuration Parameters on Default Enable Default gatewayDefault IP AddressTurbo Mode Ssid Service Set IDDefault Wireless Default Disable802.11b Wireless LAN Configuration Parameters Change Password Security Configuration For 64-bits encryption Default key size 64 bits Authentication TypeDefault Key Key Size802.11b Wireless LAN Security Parameters Key 1Access Control Access Control List Firmware UpgradeAccess Control MAC AddressAdvanced Setup Beacon Interval Transmit PowerDefault100% RTS ThresholdDefault Long Preamble TypeRestore Factory Default AP Status Station List About Setting Up Basic Wireless Connectivity Protecting Your Wireless Network Enabling Basic Wireless Access Security FeaturesBefore You Change the Ssid and WEP Settings Change the PasswordSecure the Access Point Authentication Change the Ssid Configure WEP Encryption Restrict Wireless Activity by MAC Address Protecting Your Wireless Network No lights are lit on the access point Basic FunctioningOne or both of the wireless activity lights do not light up Ethernet Link/Act light is not litTroubleshooting Compliance Regulatory Compliance Information NETGEAR, Inc