NETGEAR WAB102 Wireless Access Point Front Panel, Following table explains the LED indicators

Page 9

User’s Guide for the WAB102 802.11a+b Dual Band Wireless Access Point

WAB102 Wireless Access Point Front Panel

The WAB102 Dual Band Wireless Access Point provides these status LEDs.

	Power	Ethernet	802.11a	802.11b
			WLAN	WLAN
The following table explains the LED indicators:

LED		DESCRIPTION

Power
Off	No power. If this LED does not come on with the power adapter and
	cord correctly installed, see Chapter 4, Troubleshooting.
On	Power is on.
Blink	Indicates self test, loading software, or system fault (if continues).
	Note: This LED may blink for a minute before going on steady.
Ethernet	Link/Activity
Off	Indicates no Ethernet link detected.
Green On	100Mbps Fast Ethernet link detected, no activity
Green Blink	Indicates data traffic on the 100Mbps LAN
Amber On	10Mbps Ethernet Link detected but no activity.
Amber Blink	Indicates data traffic on the 10Mbps LAN

802.11a WLAN	Link/Activity
Off	No wireless link.
Slow Blink	Associated with network but no activity.
Fast Blink	Indicates the WAB102 802.11a wireless data transmission.

802.11b WLAN	Link/Activity
Off	No wireless link.
Slow Blink	Associated with network but no activity
Fast Blink	Indicates the WAB102 is 802.11b wireless data transmission.


6				Introduction

Image 9

Contents NETGEAR, Inc Technical Support Contents Chapter Introduction About the Wireless Access PointBenefits FeaturesWAB102 Dual Band System RequirementsCompatible and Related Netgear Products What’s In the Box?Hardware Description 802.11a+b Standards-based Wireless NetworkingFollowing table explains the LED indicators WAB102 Wireless Access Point Front PanelRestore to Factory Default Button WAB102 Wireless Access Point Rear PanelSetting Up Basic Wireless Connectivity What You Will Need Before You Begin Placement and Range GuidelinesInstallation Overview Install the WAB102 Wireless Access PointCabling Requirements Wireless Verify the installation was successful Default Factory Settings DisabledAuthentication Type Open System Determine the name of your access point Basic ConfigurationConfigure Basic Setup Parameters Log In to the Access PointFor LAN parameters, see TCP/IP Configuration Parameters on Default Default gatewayDefault Enable IP AddressDefault Wireless Ssid Service Set IDTurbo Mode Default Disable802.11b Wireless LAN Configuration Parameters Change Password Security Configuration For 64-bits encryption Default Key Authentication TypeDefault key size 64 bits Key SizeKey 1 802.11b Wireless LAN Security ParametersAccess Control Access Control Firmware UpgradeAccess Control List MAC AddressAdvanced Setup Default100% Transmit PowerBeacon Interval RTS ThresholdPreamble Type Default LongRestore Factory Default AP Status Station List About Setting Up Basic Wireless Connectivity Enabling Basic Wireless Access Security Features Protecting Your Wireless NetworkChange the Password Secure the Access PointBefore You Change the Ssid and WEP Settings Authentication Change the Ssid Configure WEP Encryption Restrict Wireless Activity by MAC Address Protecting Your Wireless Network Basic Functioning No lights are lit on the access pointEthernet Link/Act light is not lit One or both of the wireless activity lights do not light upTroubleshooting Compliance Regulatory Compliance Information NETGEAR, Inc