Linksys Etherfast manual Add Static ARP Entry, Static Route Table

Page 31

EtherFast® Series

Add Static ARP Entry

The Add Static ARP Entry screen is used to add a static ARP entry.

•IP Address - IP address statically mapped to a physical MAC address.

•MAC Address - MAC address statically mapped to the correspon- ding IP address.

•Interface - The index number of the IP interface that will use this static ARP entry. (Port “0” refers to the CPU.)

Select OK to return to the previous panel. Select Cancel to cancel any changes.

EtherFast® Managed 24-Port with Dual Gigabit Switch

Static Route Table

The Static Route Table screen is used to configure a static route.

•Destination Network - A destination network, subnet, or host.

•Destination Mask - The subnet mask that specifies the bits to match. A routing entry will be used for a packet if the bits in the address set by the destination mask match the destination network.

•VLAN - The VLAN within which the gateway or destination address resides.

•Next Hop - The IP address of the router at the next hop.

•Type - The IP route type for the destination network.

Direct - A directly connected subnetwork Indirect - A remote IP subnetwork or host address

Myself - A switch IP address on a specific IP subnetwork Bcast - A subnetwork broadcast address

Mcast - An IP multicast address

Invalid - An illegal IP address to be filtered

Select Apply to make changes. Select OK to return to the previous panel. Select Prev Page to view the previous page. Select Next Page to view the next page. To display a specific page, set the page number in the Page field and then press Apply. Select Add to add a routing entry.

56

57

Image 31

Contents EtherFast Managed 24-Port With Dual Gigabit Switch Copyright & Trademarks Introduction Table of ContentsPackage Contents Getting to Know the SwitchLEDs Gigabit Ports RJ-45 PortsConsole Port Powering on the Switch Installing the SwitchPre-Installation Considerations Rack-Mounting the SwitchOverview Switch ManagementWeb Management Logging On to the Switch Configuring the SwitchMain Menu System Information System Information MenuManagement Setup Menu Switch InformationIP Configuration Network ConfigurationIP Connectivity Test Ping Http ConfigurationSnmp Configuration Serial Port ConfigurationIP Trap Managers Snmp CommunitiesAdd User User ConfigurationTftp Download Configuration FileDevice Control Menu Layer 2 Menu System ModeMirror Port Configuration Port ConfigurationStatic Unicast Address Configuration Port Trunking ConfigurationAdd Static Address Entry Static Multicast Address ConfigurationBridge Menu Add Multicast Address EntrySpanning Tree Port Configuration Bridge ConfigurationVlan Menu Vlan Port ConfigurationVlan and Priority Vlan Table ConfigurationIP Menu Subnet ConfigurationAdd Subnet Protocol ConfigurationRIP Configuration ARP ConfigurationAdd Bootp Relay Server Bootp Relay Database ConfigurationStatic ARP Table Static Route Table Add Static ARP EntryAdd Routing Entry Default Route MenuSecurity Menu MAC Filtering ConfigurationAdd IP Address Filter Security ModeIP Security Filtering Configuration Add MAC Address FilterNetwork Monitor Menu Igmp Snooping ConfigurationPort Statistics Port Statistics/Statistics MenuInterfaces Group Ethernet-Like Rmon Statistics Layer 2 Address Table Spanning Tree Port Information Spanning Tree Bridge InformationVlan Information Vlan Forwarding Information Vlan Dynamic Registration InformationIP Multicast Registration Table ARP Table Subnet InformationMulticast Table Menu Routing TableIgmp Cache Dvmrp Routing Table Multicast Forwarding CacheSystem Restart Menu Dvmrp Neighbor TableCommon Problems and Solutions TroubleshootingExit Tion Appendix Your firmware has now been updatedUpgrading Firmware via the Serial Port Glossary 101 103 Warranty Information SpecificationsEnvironmental Web FTP Site Tech Support RMA Issues FaxContact Information Sales InformationT p / / w w w. l i n k s y s . c o m