Linksys Etherfast manual Ethernet-Like

Page 37

EtherFast® Series

•In Errors - The number of inbound packets that contained errors pre- venting them from being deliverable to a higher-layer protocol.

•Alignment Errors - The number of alignment errors (mis-synchronized data packets).

•Out Octets - The total number of octets transmitted out of the interface, including framing characters.

•Out Unicast Pkts - The total number of packets that higher-level proto- cols requested be transmitted to a subnetwork-unicast address, including those that were discarded or not sent.

•Out Non-Unicast Pkts - The total number of packets that higher-level protocols requested be transmitted to a non-unicast (that is, a subnet- work-broadcast or subnetwork-multicast) address, including those that were discarded or not sent.

•Out Discards - The number of outbound packets which were chosen to be discarded even though no errors had been detected to prevent their being transmitted. One possible reason for discarding such a packet could be to free up buffer space.

•Out Errors - The number of outbound packets that could not be trans- mitted because of errors.

•CRC Errors - Number of Ethernet Cyclic Redundancy Check errors detected by this device.

Ethernet-Like

•Single Collisions - The number of successfully transmitted frames for which transmission is inhibited by exactly one collision.

•Deferred Transmissions - A count of frames for which the first trans- mission attempt on a particular interface is delayed because the medium was busy.

•Excessive Collisions - The number of frames for which transmission failed due to excessive collisions.

EtherFast® Managed 24-Port with Dual Gigabit Switch

•Drop Events - The total number of events in which packets were dropped due to lack of resources.

•Octets - Number of octets passing through this port.

•Multiple Collisions - A count of successfully transmitted frames for which transmission is inhibited by more than one collision.

•Late Collisions - The number of times that a collision is detected later than 512 bit-times into the transmission of a packet.

•Carrier Sense Errors - The number of times that the carrier sense con- dition was lost or never asserted when attempting to transmit a frame.

•Fragments - The total number of frames received that were less than 64 octets in length (excluding framing bits, but including FCS octets) and had either an FCS or alignment error.

•Jabbers - The total number of frames received that were longer than 1518 octets (excluding framing bits, but including FCS octets), and had either an FCS or alignment error.

Select Apply to make changes. Select Refresh to refresh the statistics. Select OK to return to the previous panel. Select Reset to reset a specific statistic. Select Reset All to reset the all statistics. Select Prev Port to view the previ- ous port. Select Next Port to view the next port. To display a specific port, set the port number in the Port field and then press Apply.

68

69

Page 36 Page 38
Image 37
Page 36 Page 38
Contents EtherFast Managed 24-Port With Dual Gigabit Switch Copyright & Trademarks Introduction Table of ContentsPackage Contents Getting to Know the SwitchLEDs Gigabit Ports RJ-45 PortsConsole Port Pre-Installation Considerations Installing the SwitchRack-Mounting the Switch Powering on the SwitchOverview Switch ManagementWeb Management Logging On to the Switch Configuring the SwitchMain Menu System Information System Information MenuManagement Setup Menu Switch InformationIP Configuration Network ConfigurationIP Connectivity Test Ping Http ConfigurationSnmp Configuration Serial Port ConfigurationIP Trap Managers Snmp CommunitiesAdd User User ConfigurationTftp Download Configuration FileDevice Control Menu Layer 2 Menu System ModeMirror Port Configuration Port ConfigurationStatic Unicast Address Configuration Port Trunking ConfigurationAdd Static Address Entry Static Multicast Address ConfigurationBridge Menu Add Multicast Address EntrySpanning Tree Port Configuration Bridge ConfigurationVlan Menu Vlan Port ConfigurationVlan and Priority Vlan Table ConfigurationIP Menu Subnet ConfigurationAdd Subnet Protocol ConfigurationRIP Configuration ARP ConfigurationAdd Bootp Relay Server Bootp Relay Database ConfigurationStatic ARP Table Static Route Table Add Static ARP EntryAdd Routing Entry Default Route MenuSecurity Menu MAC Filtering ConfigurationIP Security Filtering Configuration Security ModeAdd MAC Address Filter Add IP Address FilterNetwork Monitor Menu Igmp Snooping ConfigurationPort Statistics Port Statistics/Statistics MenuInterfaces Group Ethernet-Like Rmon Statistics Layer 2 Address Table Spanning Tree Port Information Spanning Tree Bridge InformationVlan Information Vlan Forwarding Information Vlan Dynamic Registration InformationIP Multicast Registration Table ARP Table Subnet InformationMulticast Table Menu Routing TableIgmp Cache Dvmrp Routing Table Multicast Forwarding CacheSystem Restart Menu Dvmrp Neighbor TableCommon Problems and Solutions TroubleshootingExit Tion Appendix Your firmware has now been updatedUpgrading Firmware via the Serial Port Glossary 101 103 Warranty Information SpecificationsEnvironmental Contact Information Tech Support RMA Issues FaxSales Information Web FTP SiteT p / / w w w. l i n k s y s . c o m
Top Page Image Contents