Linksys Etherfast manual Web Management

Page 8

EtherFast® Series

4.When the following screen appears, make sure that the Switch’s serial port settings are as follows:

BAUD RATE: 19200

DATA BITS: 8

PARITY: None

STOP BITS: 1

FLOW CONTROL: None

Click the OK button.

Web Management

Web management is available after the Switch has been configured with a valid IP address, subnet mask, and default gateway (for Layer 2 mode) via the console interface. Use a standard Web browser (Internet Explorer 4.0 or above, or Netscape Navigator 4.0 or above is suggested) from any computer attached to the network. The Switch has a default IP address of 192.168.1.254 and a default subnet address of 255.255.255.0.

EtherFast® Managed 24-Port with Dual Gigabit Switch

Telnet Management

Telnet management is available after the Switch has been configured with a valid IP address, subnet mask, and default gateway (for Layer 2 mode) via the console interface. Use telnet from any computer attached to the network.

SNMP/RMON Management

SNMP/RMON management is available after the Switch has been configured with a valid IP address, subnet mask, and default gateway (for Layer 2 mode) via the console interface. Manage the Switch from any network computer using network management software.

Note: The Switch’s configuration program only provides access to basic configuration functions. To access the full range of SNMP management functions, you must use SNMP-based network management software.

10

11

Image 8

Contents EtherFast Managed 24-Port With Dual Gigabit Switch Copyright & Trademarks Table of Contents IntroductionLEDs Getting to Know the SwitchPackage Contents Console Port RJ-45 PortsGigabit Ports Installing the Switch Pre-Installation ConsiderationsRack-Mounting the Switch Powering on the SwitchSwitch Management OverviewWeb Management Main Menu Configuring the SwitchLogging On to the Switch System Information Menu System InformationSwitch Information Management Setup MenuNetwork Configuration IP ConfigurationHttp Configuration IP Connectivity Test PingSerial Port Configuration Snmp ConfigurationSnmp Communities IP Trap ManagersUser Configuration Add UserConfiguration File Tftp DownloadDevice Control Menu System Mode Layer 2 MenuPort Configuration Mirror Port ConfigurationPort Trunking Configuration Static Unicast Address ConfigurationStatic Multicast Address Configuration Add Static Address EntryAdd Multicast Address Entry Bridge MenuBridge Configuration Spanning Tree Port ConfigurationVlan Port Configuration Vlan MenuVlan Table Configuration Vlan and PrioritySubnet Configuration IP MenuProtocol Configuration Add SubnetARP Configuration RIP ConfigurationStatic ARP Table Bootp Relay Database ConfigurationAdd Bootp Relay Server Add Static ARP Entry Static Route TableDefault Route Menu Add Routing EntryMAC Filtering Configuration Security MenuSecurity Mode IP Security Filtering ConfigurationAdd MAC Address Filter Add IP Address FilterIgmp Snooping Configuration Network Monitor MenuInterfaces Group Port Statistics/Statistics MenuPort Statistics Ethernet-Like Rmon Statistics Layer 2 Address Table Spanning Tree Bridge Information Spanning Tree Port InformationVlan Information Vlan Dynamic Registration Information Vlan Forwarding InformationIP Multicast Registration Table Subnet Information ARP TableRouting Table Multicast Table MenuIgmp Cache Multicast Forwarding Cache Dvmrp Routing TableDvmrp Neighbor Table System Restart MenuExit TroubleshootingCommon Problems and Solutions Tion Upgrading Firmware via the Serial Port Your firmware has now been updatedAppendix Glossary 101 103 Environmental SpecificationsWarranty Information Tech Support RMA Issues Fax Contact InformationSales Information Web FTP SiteT p / / w w w. l i n k s y s . c o m