Airlink101 AR695W manual Advanced Setting, System Time, Select Get Date and Time by NTP Protocol

Page 76

3.4 Advanced Setting

This page allows you to set up system time, log, DDNS, routing, QoS, schedule rule, and other advanced settings.

3.4.1 System Time

Specify correct system time for your router is very important. It will affect the schedule rule and system logs. This router provides 3 ways to configure the system date and time:

1)Synchronize with time server. (The router must connect to the Internet.)

>Select Get Date and Time by NTP Protocol

2)Synchronize with PC.

>Select Set Date and Time using PC’s Date and Time

3)Manually configure the time

>Select Set Date and Time manually

72

Image 76
Contents Wireless N 300 Gigabit Green Router Copyright Table of Contents Status Introduction and safety information Product InformationPackage Contents Familiar with your new Gigabit Router Front PanelBack Panel Configure the Router Connect the Router to your networkPage Configure the Router with EZ Setup Wizard Select your language and click Next Click on Wizard Page Page Cable Dynamic IP Example username@sbcglobal.net Page Page Configure the Router with Web Configuration Utility Page Page For Cable Users Dynamic IP Address Click on Clone MAC Example username@sbcglobal.net Page Page Connect to Router Wirelessly Page Advanced Configuration Page Basic Setting Primary Setup LAN IP AddressWAN Type Virtual ComputersPage Static IP Address Dynamic IP AddressWAN’s MAC Address Host NameRenew IP Forever Password Login ServerDynamic IP Address with Road Runner Session Management AccountPPP Over Ethernet PPPoE PPPoE Service Name Assigned IP AddressIP Mode Pptp PasswordMy IP Address My Subnet MaskL2TP Password L2TP AccountGlobal IP EnableLocal IP Dhcp Server Dhcp ServerLease Time IP Pool Starting/Ending AddressPrimary DNS/Secondary DNS Primary WINS/Secondary WinsGateway Client ListWireless Wireless Mode Wireless Client ListSsid Broadcast ChannelConfiguring Security WEP Configuring Security WPA-PSK / WPA2-PSKConfiguring Security 802.1x and Radius Configuring Security WPA / WPA2 3.1 WDS AP Mode Remote AP MACScanned AP’s MAC Scan APWPS Easy Setup Button Page Page Select Enable or Disable WPS function WPS State WPS StatusChange Password Old PasswordNew Password ReconfirmWell known services Service PortsForwarding Rules Virtual ServerSchedule Rule# ProtocolNext / Previous Special Applications Popular applicationsTrigger Incoming PortsMiscellaneous IP Address of DMZ HostSuper DMZ IP Passthrough Non-standard FTP PortUPnP Xbox SupportSecurity Setting Packet FilteringOutbound/Inbound Packet FilterSource IP Destination IPPort Inbound FilterDomain Blocking Recorded in log file URL Blocking URL BlockingInternet Access Control Page MAC Address Control MAC Access ControlAssociation Control MAC Address Dhcp ClientsPrevious / Next Group MAC Access Control Group MAC Access ControlAdd MAC Address Interface Access Control Interface Access ControlInterface Schedule Rule DenySPI Mode Discard Ping from WAN sideDoS Attack Detection VPN Pptp Pass-ThroughAdvanced Setting Select Set Date and Time using PC’s Date and TimeSystem Time Select Get Date and Time by NTP ProtocolSystem Time Sync NowTime Server Time ZoneSystem Log IP Address of Syslog ServerEmail Alert Send Mail NowEmail Addresses Email SubjectUsername Log TypePassword / Key Dynamic DNSProvider Provider WebsiteQoS Rule QoS ControlPorts Remote IP AddressQoS Priority Snmp Routing AR695W Dynamic RoutingStatic Routing DestinationSubnet Mask HopSchedule Rule ScheduleRule# Rule NameWeek Day Name of Rule#Start Time/End Time hhmm Toolbox View Log Firmware Upgrade Backup Setting Reset to DefaultReboot Domain Name or IP Address for Ping Test Status Wireless Status System StatusStatistics Information NAT StatusHardware Specification Technical Support