Airlink101 AR695W manual Static Routing, Destination, Subnet Mask, Hop

Page 86

Static Routing	Select Enable or Disable to enable or disable Static Routing
	function.
Destination	Enter a destination IP address. The Destination IP is the address
	of the remote network or host to which you want to assign a static
	route.
Subnet Mask	Enter the subnet mask. The Subnet Mask determines which
	portion of a Destination IP address is the network portion, and
	which portion is the host portion.
Gateway	Enter the gateway IP address. This is the IP address of the
	gateway device that allows for contact between the Router and
	the remote network or host.
Hop	Specify the number of next hop.
Enable	Check or uncheck Enable to enable or disable the static routing
	rule.

Click on Save after you finished all settings.

82

Image 86

Contents Wireless N 300 Gigabit Green Router Copyright Table of Contents Status Introduction and safety information Product InformationPackage Contents Familiar with your new Gigabit Router Front PanelBack Panel Configure the Router Connect the Router to your networkPage Configure the Router with EZ Setup Wizard Select your language and click Next Click on Wizard Page Page Cable Dynamic IP Example username@sbcglobal.net Page Page Configure the Router with Web Configuration Utility Page Page For Cable Users Dynamic IP Address Click on Clone MAC Example username@sbcglobal.net Page Page Connect to Router Wirelessly Page Advanced Configuration Page Basic Setting WAN Type Primary SetupLAN IP Address Virtual ComputersPage Static IP Address Dynamic IP AddressRenew IP Forever Host NameWAN’s MAC Address Dynamic IP Address with Road Runner Session Management PasswordLogin Server AccountPPP Over Ethernet PPPoE PPPoE Service Name Assigned IP AddressMy IP Address IP ModePptp Password My Subnet MaskL2TP Password L2TP AccountLocal IP EnableGlobal IP Lease Time Dhcp ServerDhcp Server IP Pool Starting/Ending AddressGateway Primary DNS/Secondary DNSPrimary WINS/Secondary Wins Client ListWireless Ssid Broadcast Wireless ModeWireless Client List ChannelConfiguring Security WEP Configuring Security WPA-PSK / WPA2-PSKConfiguring Security 802.1x and Radius Configuring Security WPA / WPA2 3.1 WDS Scanned AP’s MAC AP ModeRemote AP MAC Scan APWPS Easy Setup Button Page Page Select Enable or Disable WPS function WPS State WPS StatusNew Password Change PasswordOld Password ReconfirmForwarding Rules Well known servicesService Ports Virtual ServerNext / Previous ProtocolSchedule Rule# Trigger Special ApplicationsPopular applications Incoming PortsMiscellaneous IP Address of DMZ HostUPnP Super DMZ IP PassthroughNon-standard FTP Port Xbox SupportSecurity Setting Packet FilteringSource IP Outbound/InboundPacket Filter Destination IPPort Inbound FilterDomain Blocking Recorded in log file URL Blocking URL BlockingInternet Access Control Page Association Control MAC Access ControlMAC Address Control Previous / Next Dhcp ClientsMAC Address Add MAC Address Group MAC Access ControlGroup MAC Access Control Interface Interface Access ControlInterface Access Control Schedule Rule DenyDoS Attack Detection SPI ModeDiscard Ping from WAN side VPN Pptp Pass-ThroughSystem Time Advanced SettingSelect Set Date and Time using PC’s Date and Time Select Get Date and Time by NTP ProtocolTime Server System TimeSync Now Time ZoneEmail Alert System LogIP Address of Syslog Server Send Mail NowUsername Email AddressesEmail Subject Log TypeProvider Password / KeyDynamic DNS Provider WebsiteQoS Rule QoS ControlQoS Priority Remote IP AddressPorts Snmp Routing AR695W Dynamic RoutingSubnet Mask Static RoutingDestination HopRule# Schedule RuleSchedule Rule NameStart Time/End Time hhmm Name of Rule#Week Day Toolbox View Log Firmware Upgrade Backup Setting Reset to DefaultReboot Domain Name or IP Address for Ping Test Status Wireless Status System StatusStatistics Information NAT StatusHardware Specification Technical Support