Configuring the IPR-S1000
tftpput: Allows to put a kernel or a profile on the specified TFTP server.
version: Displays two version numbers. The first one is the system version, and the second one is the version of the satellite reception’s software.
traceroute + IP address or «host» name
Prints the route that packets take to reach network host.
numeric: Prints hop addresses numerically rather than symbolically and numerically.
timeout: The process of traceroute will not exceed nsecond.
tos: Sets the type of service in probe packets to the following value (default zero). The value must be a decimal integer in the range 0 to 255.
verbose: Verbose output. Received ICMP packets other than TIME_EXCEEDED and UNREACHABLEs are listed.
wait: Sets the time (in seconds) to wait for a response to a probe (default 5 sec.).
tsdump
TS Dump is an
display_dump_date: If selected, ts dump will display the start and end dates at the end of the dump.
display_pid_nbr: If selected, ts dump will display the PID number before each TS packet.
diplay_pid_rate: If selected, ts dump will display each PIDs bit rate at the end of the dump.
display_pkt_count: If selected, ts dump will display the number of TS packets received for each PID at the end of the dump.
display_which_bytes: The number of displayed octets for each packet.
display_which_pkts: The interveal of packages between two postings.
ftp_addr: Access parameters to FTP server which will store TS flow.
ftp_login: Access parameters to FTP server which will store TS flow.
ftp_passwd: Access parameters to FTP server which will store TS flow.
ftp_path: Access parameters to FTP server which will store TS flow.
ftp_port: Access parameters to FTP server which will store TS flow.
mode_ftp: Selects the FTP analysis mode.
mode_hexa: Screen select mode (hexadecimal format).
mode_hexaline: Screen select mode (hexaline format).
mode_hexdump: Screen select mode (hexdump format).
mod_stat: Displays statistics only, not packages.
86