ADTRAN IPR-S1000 Abort, Auth Authentication, Bye, Delete + name of the profile to be removed

Configuring the IPR-S1000

abort

Allows to abort modifications after one or many set command.

auth (Authentication)

Allows to change the authentication level, i.e to switch to the public, read or write level. A password is needed only when switching to a more restricted level.

read: Allows to read the whole IPR-S1000 set up. The user cannot configure the IPR-S1000.

write: Allows a complete configuration access, and allows to change the set up parameters.

bye

Allows to exit the shell.

default + name of the profile that will become the starting profile Allows to make a profile the startup profile.

defaultfactory

Allows to make the factory profile the startup profile.

delete + name of the profile to be removed

Allows to remove a profile.

dvb (Digital Video Broadcast)

Real-time access to the DVB interface.

dlevel: Digital level in percent.

fec: Current FEC, useful if FEC auto is enabled.

lock: Yes if locked, No otherwise.

macaddress: MAC address of this interface (it cannot be modified).

macaddresses: List of all MAC addresses currently treated by the receiver card.

mpebytes: Amount of bytes received at MPE level on the satellite interface.

mpepackets: Amount of IP packets received through MPE on the satellite interface.

sn: Eb/No. Signal noise ratio in dB.

temp: The temperature (given in celcius degree) of the warmest point to be found in the equipment.

uncor.: Total number of packets that could not be corrected by the demodulator.

vber: Rate of erroneous bits before Read Salomon (for example, a VBER of 1.7E-4> indicates that 1.7 bits are erroneous every 10000 bits).

dvbdump

Table dump.

77