ADTRAN 1202890E1 manual Unit Installation

Page 46

Unit Installation	NetVanta 4300/4400 Series

4.UNIT INSTALLATION

The instructions and guidelines provided in this section cover hardware installation topics, such as wall mounting/rack mounting the unit and installing option cards. These instructions are presented as follows:

•Mounting Options on page 47

•Supplying Power to the Unit on page 49

•Installing Dial Backup and Network Interface Modules on page 51

•Using a USB Cellular Modem with the NetVanta USB WWAN NIM on page 53

•Installing the NetVanta VPN Accelerator Card (included in P/N 4200368L1) on page 54

•Installing a SODIMM for Expandable Memory on page 55

•Installing a CompactFlash Card on page 57

For information on router configuration for a specific application, refer to the configuration guides provided on the ADTRAN Support Community. For details on the command line interface (CLI), refer to the AOS Command Reference Guide. All other related documents are also available online at

http://supportforums.adtran.com.

To prevent electrical shock, do not install equipment in a wet location or during an electrical storm.

The NetVanta 4000 Series is intended to be installed, maintained, and serviced by qualified service personnel only and should be installed in a restricted access location as described in UL/IEC 60950-1.

Ethernet cables are intended for intrabuilding use only. Connecting an ADTRAN unit directly to Ethernet cables that run outside the building in which the unit is housed will void the user's warranty and could create a fire or shock hazard. To connect an ADTRAN unit to Ethernet cables that run outside the building, ADTRAN's Ethernet Port Protection Device (EPPD) (P/N 1700502G1) must be connected between the unit and the outside plant cable. Use of any Ethernet protector other than ADTRAN's for this purpose will void the user's warranty.

46

Copyright © 2013 ADTRAN, Inc.

61200890E2-34R

Image 46

Contents NetVanta 4300/4400 Series To the Holder of the Manual TrademarksSoftware Licensing Agreement Conventions Safety Instructions Save These Important Safety InstructionsFCC-Required Information REN/SOC FIC UsocIsdn BRI DIM Service and Warranty Toll Fraud LiabilityService and Warranty NetVanta 4300/4400 Series Table of Contents Table of Contents NetVanta 4300/4400 Series Appendix A. Connector Pin DefinitionsList of Figures List of Figures NetVanta 4300/4400 Series List of Tables List of Tables NetVanta 4300/4400 Series Introduction NetVanta 4305 Features and Specifications NetVantaNetVanta 4305 Shipping Contents NetVanta 4305 Rear Panel Design NetVanta 4305 Front Panel DesignNET/DBU and Wide Module Option Slots Power Supply NetVanta 4430 Features and Specifications10/100Base-T Ethernet Interface and Activity LEDs SFP Module Slots NetVanta 4430 Shipping Contents NetVanta 4430 Domestic Shipping Contents NetVanta 4305 International Shipping ContentsNetVanta 4430 Rear Panel Design CompactFlashNetVanta 4300/4400 Series LEDs NetVanta 4300/4400 Series Front Panel LEDsColor Indication Option Modules Option Module Shipping Contents NetVanta Adsl NIM, Annex a 1202869E1 NetVanta E1/FE1 + G.703 Drop NIM 1200878E1/L1NetVanta Serial NIM 1200866E1 NetVanta Adsl NIM, Annex B 1202889E1NetVanta Isdn S/T DIM 1200875L1 NetVanta Analog Modem DIM 1200864L1NetVanta Isdn BRI DIM 1200865L1 NetVanta VPN Accelerator Card 1202368L1Network Interface Modules NetVanta 56K/64K NIM P/N 1200861L1NetVanta T1/FT1 NIM P/N 1202862L1 Operating Modes DiagnosticsT1/FT1 Interface NetVanta T1/FT1 Nebs NIM P/N 1200862L2#NEBS Operating ModesOperating Modes Clock Source NetVanta T1/FT1 + DSX-1 NIM P/N 1202863L1DSX-1 Interface NetVanta Dual T1 NIM P/N 1200872L1/1202872L1 T1 Interface8xT1 Interfaces NetVanta Octal T1/E1 Wide Module P/N 1202843E18xE1 Interfaces T1/E1 Mode DIP Switch WAN-E1 Interface NetVanta E1/FE1 NIM P/N 1200868E1/L1Clock Source Physical NetVanta E1/FE1 + G.703 Drop NIM P/N 1200878E1/L1 InterfaceNetVanta Serial NIM P/N 1200866E1 Operating Mode EnvironmentalSerial Interface NetVanta Adsl NIM, Annex a P/N 1202869E1 DSL Interface ComplianceNetVanta Adsl NIM, Annex B P/N 1202889E1 Adsl Interface ComplianceNetVanta Shdsl NIM, Annex a P/N 1200936E1 Operating ModeShdsl Interface NetVanta Shdsl NIM, Annex B P/N 1200937E1 NetVanta Shdsl NIM, Annex BNetVanta USB Wwan NIM P/N 1702803F1 USB Interface Environmental Features Dial Backup Interface Modules NetVanta Analog Modem DIM P/N 1200864L1 NetVanta Isdn BRI DIM P/N 1200865L1 NetVanta Isdn S/T DIM P/N 1200875L1 Etsi TBRUnit Installation Mounting Options Tools RequiredRack Mounting NetVanta 4300/4400 Series Instructions for Wall Mounting the NetVanta Wall Mounting NetVanta 4300/4400 SeriesStep Action Supplying Power to the Unit NetVanta 4305 AC and NetVantaInstructions for Connecting DC Power Source to the NetVanta NetVanta 4305 DCInstalling Dial Backup and Network Interface Modules Installing DIMsNIM and DIM Installation Using a USB Cellular Modem with the NetVanta USB Wwan NIM Instructions for Installing the VPN Accelerator Card NetVanta VPN Accelerator Card InstallationInstalling a Sodimm for Expandable Memory Instructions for Installing a SodimmSodimm Installation Keyed Slots Installing a CompactFlash Card Instructions for Installing a CompactFlash CardUnit Installation NetVanta 4300/4400 Series Appendix A. Connector PIN Definitions Table A-1 /100Base-T Ethernet Port Pinouts Name DescriptionTable A-3. SFP Slot Pinouts Name Table A-4. Console Port DCE Pinouts Name DescriptionTable A-7. WAN-E1 Connector Pinouts Table A-5. WAN-DDS Connector Pinouts Name DescriptionTable A-6. WAN-T1 Connector Pinouts Pin Name DescriptionTable A-10. WAN-ADSL NIM Connector Pinouts Table A-8. DSX-1 Connector Pinouts Name DescriptionTable A-9. G.703 Connector Pinouts Table A-11. WAN-SHDSL Connector PinoutsTable A-13. Serial to Cable Pinouts Table A-12. USB Wwan Connector Pinouts Name DescriptionEIA Pin Dial Backup Interface Module Pinouts DBU Connector Table A-15. Isdn S/T DBU Connector Pinouts