ADTRAN 1202890E1 manual Supplying Power to the Unit, NetVanta 4305 AC and NetVanta

Page 49

NetVanta 4300/4400 Series						Unit Installation

Figure 20. Wall Mounting the Unit

Supplying Power to the Unit

As shipped, each NetVanta 4000 is set to factory default conditions. After installing the base unit and any option modules, the NetVanta 4000 is ready for power up. To power the unit, ensure that the unit is properly connected to an appropriate power source (as outlined in the sections below).

NetVanta 4305 (AC) and NetVanta 4430

The AC-powered NetVanta 4305 and NetVanta 4430 units come equipped with an auto-sensing 100 to 250 VAC, 50/60 Hz power supply. All appropriate power cords are included in the shipment of the units. To power these units, connect the power cable to an appropriately grounded power source.

•Install unit in accordance with Article 400 and 364.8 of NEC NFPA 70.

• Maximum recommended ambient operating temperature is 50°C.

Previous versions of the NetVanta 4430 were equipped with either a 120 VAC, 50/60 Hz (1700630G1#120) or 240 VAC, 50/60 Hz (1700630G1#240) power supply. Plugging these units into an incompatible power source will damage the unit. Refer to the label on the unit before connecting the unit to the power source.

61200890E2-34R

Copyright © 2013 ADTRAN, Inc.

49

Image 49

Contents NetVanta 4300/4400 Series To the Holder of the Manual TrademarksSoftware Licensing Agreement Conventions Save These Important Safety Instructions Safety InstructionsREN/SOC FIC Usoc FCC-Required InformationIsdn BRI DIM Toll Fraud Liability Service and WarrantyService and Warranty NetVanta 4300/4400 Series Table of Contents Appendix A. Connector Pin Definitions Table of Contents NetVanta 4300/4400 SeriesList of Figures List of Figures NetVanta 4300/4400 Series List of Tables List of Tables NetVanta 4300/4400 Series Introduction NetVanta NetVanta 4305 Features and SpecificationsNetVanta 4305 Shipping Contents NetVanta 4305 Rear Panel Design NetVanta 4305 Front Panel DesignNET/DBU and Wide Module Option Slots Power Supply NetVanta 4430 Features and Specifications10/100Base-T Ethernet Interface and Activity LEDs SFP Module Slots NetVanta 4430 Shipping Contents NetVanta 4305 International Shipping Contents NetVanta 4430 Domestic Shipping ContentsCompactFlash NetVanta 4430 Rear Panel DesignNetVanta 4300/4400 Series LEDs NetVanta 4300/4400 Series Front Panel LEDsColor Indication Option Modules Option Module Shipping Contents NetVanta Serial NIM 1200866E1 NetVanta E1/FE1 + G.703 Drop NIM 1200878E1/L1NetVanta Adsl NIM, Annex a 1202869E1 NetVanta Adsl NIM, Annex B 1202889E1NetVanta Isdn BRI DIM 1200865L1 NetVanta Analog Modem DIM 1200864L1NetVanta Isdn S/T DIM 1200875L1 NetVanta VPN Accelerator Card 1202368L1NetVanta 56K/64K NIM P/N 1200861L1 Network Interface ModulesNetVanta T1/FT1 NIM P/N 1202862L1 Operating Modes DiagnosticsT1/FT1 Interface Operating Modes NetVanta T1/FT1 Nebs NIM P/N 1200862L2#NEBSOperating Modes Clock Source NetVanta T1/FT1 + DSX-1 NIM P/N 1202863L1DSX-1 Interface T1 Interface NetVanta Dual T1 NIM P/N 1200872L1/1202872L18xT1 Interfaces NetVanta Octal T1/E1 Wide Module P/N 1202843E18xE1 Interfaces T1/E1 Mode DIP Switch WAN-E1 Interface NetVanta E1/FE1 NIM P/N 1200868E1/L1Clock Source Physical Interface NetVanta E1/FE1 + G.703 Drop NIM P/N 1200878E1/L1NetVanta Serial NIM P/N 1200866E1 Operating Mode EnvironmentalSerial Interface DSL Interface Compliance NetVanta Adsl NIM, Annex a P/N 1202869E1Adsl Interface Compliance NetVanta Adsl NIM, Annex B P/N 1202889E1NetVanta Shdsl NIM, Annex a P/N 1200936E1 Operating ModeShdsl Interface NetVanta Shdsl NIM, Annex B NetVanta Shdsl NIM, Annex B P/N 1200937E1USB Interface Environmental NetVanta USB Wwan NIM P/N 1702803F1Features Dial Backup Interface ModulesNetVanta Analog Modem DIM P/N 1200864L1 NetVanta Isdn BRI DIM P/N 1200865L1 Etsi TBR NetVanta Isdn S/T DIM P/N 1200875L1 Unit Installation Mounting Options Tools RequiredRack Mounting NetVanta 4300/4400 Series Instructions for Wall Mounting the NetVanta Wall Mounting NetVanta 4300/4400 SeriesStep Action NetVanta 4305 AC and NetVanta Supplying Power to the UnitNetVanta 4305 DC Instructions for Connecting DC Power Source to the NetVantaInstalling DIMs Installing Dial Backup and Network Interface ModulesNIM and DIM Installation Using a USB Cellular Modem with the NetVanta USB Wwan NIM NetVanta VPN Accelerator Card Installation Instructions for Installing the VPN Accelerator CardInstructions for Installing a Sodimm Installing a Sodimm for Expandable MemorySodimm Installation Keyed Slots Instructions for Installing a CompactFlash Card Installing a CompactFlash CardUnit Installation NetVanta 4300/4400 Series Table A-1 /100Base-T Ethernet Port Pinouts Name Description Appendix A. Connector PIN DefinitionsTable A-4. Console Port DCE Pinouts Name Description Table A-3. SFP Slot Pinouts NameTable A-6. WAN-T1 Connector Pinouts Table A-5. WAN-DDS Connector Pinouts Name DescriptionTable A-7. WAN-E1 Connector Pinouts Pin Name DescriptionTable A-9. G.703 Connector Pinouts Table A-8. DSX-1 Connector Pinouts Name DescriptionTable A-10. WAN-ADSL NIM Connector Pinouts Table A-11. WAN-SHDSL Connector PinoutsTable A-13. Serial to Cable Pinouts Table A-12. USB Wwan Connector Pinouts Name DescriptionEIA Pin Table A-15. Isdn S/T DBU Connector Pinouts Dial Backup Interface Module Pinouts DBU Connector