ADTRAN 1202890E1 manual Installing Dial Backup and Network Interface Modules, Installing DIMs

Page 51

NetVanta 4300/4400 Series	Unit Installation

Installing Dial Backup and Network Interface Modules

The DIMs plug onto the NIMs. The NIMs are then installed in the rear panel option module slot. The following tables list the installation steps. See Figure 21 on page 51 below and Figure 22 on page 52.

For NetVanta modules with outside plant connections, ensure that all cables are removed from all modules before installing or removing it from the NetVanta chassis.

		Electronic modules can be damaged by static electrical discharge. Before handling
		modules, wear an antistatic discharge wrist strap to prevent damage to electrical
		components. Place modules in antistatic packing material when transporting or storing.

		When working on modules, always place them on an approved antistatic mat that is
		electrically grounded.


		Instructions for Installing the DIMs

Step		Action

1Remove power from the unit.

2If the NIM is already installed in the NetVanta chassis, remove all cables, release the pins at both edges of the NIM front panel, and slide the module out of the chassis.

3Carefully align the P1 connector on the NIM with the J1 connector on the DIM. Using only fingertip pressure so that neither circuit board bends or flexes, ensure that the connectors are firmly seated. Secure the DIM to the NIM using the screws and standoff posts supplied. See Figure 21.

4Slide the NIM with the DIM attached into the NetVanta chassis, continuing with the normal NIM installation (refer to Instructions for Installing the NIMs and Wide NIMs on page 52).

Figure 21. Installing DIMs

61200890E2-34R

Copyright © 2013 ADTRAN, Inc.

51

Image 51

Contents NetVanta 4300/4400 Series Trademarks To the Holder of the ManualSoftware Licensing Agreement Conventions Save These Important Safety Instructions Safety InstructionsREN/SOC FIC Usoc FCC-Required InformationIsdn BRI DIM Toll Fraud Liability Service and WarrantyService and Warranty NetVanta 4300/4400 Series Table of Contents Appendix A. Connector Pin Definitions Table of Contents NetVanta 4300/4400 SeriesList of Figures List of Figures NetVanta 4300/4400 Series List of Tables List of Tables NetVanta 4300/4400 Series Introduction NetVanta NetVanta 4305 Features and SpecificationsNetVanta 4305 Shipping Contents NetVanta 4305 Front Panel Design NetVanta 4305 Rear Panel DesignNET/DBU and Wide Module Option Slots NetVanta 4430 Features and Specifications Power Supply10/100Base-T Ethernet Interface and Activity LEDs SFP Module Slots NetVanta 4430 Shipping Contents NetVanta 4305 International Shipping Contents NetVanta 4430 Domestic Shipping ContentsCompactFlash NetVanta 4430 Rear Panel DesignNetVanta 4300/4400 Series Front Panel LEDs NetVanta 4300/4400 Series LEDsColor Indication Option Modules Option Module Shipping Contents NetVanta Adsl NIM, Annex B 1202889E1 NetVanta E1/FE1 + G.703 Drop NIM 1200878E1/L1NetVanta Serial NIM 1200866E1 NetVanta Adsl NIM, Annex a 1202869E1NetVanta VPN Accelerator Card 1202368L1 NetVanta Analog Modem DIM 1200864L1NetVanta Isdn BRI DIM 1200865L1 NetVanta Isdn S/T DIM 1200875L1NetVanta 56K/64K NIM P/N 1200861L1 Network Interface ModulesOperating Modes Diagnostics NetVanta T1/FT1 NIM P/N 1202862L1T1/FT1 Interface Operating Modes NetVanta T1/FT1 Nebs NIM P/N 1200862L2#NEBSNetVanta T1/FT1 + DSX-1 NIM P/N 1202863L1 Operating Modes Clock SourceDSX-1 Interface T1 Interface NetVanta Dual T1 NIM P/N 1200872L1/1202872L1NetVanta Octal T1/E1 Wide Module P/N 1202843E1 8xT1 Interfaces8xE1 Interfaces T1/E1 Mode DIP Switch NetVanta E1/FE1 NIM P/N 1200868E1/L1 WAN-E1 InterfaceClock Source Physical Interface NetVanta E1/FE1 + G.703 Drop NIM P/N 1200878E1/L1Operating Mode Environmental NetVanta Serial NIM P/N 1200866E1Serial Interface DSL Interface Compliance NetVanta Adsl NIM, Annex a P/N 1202869E1Adsl Interface Compliance NetVanta Adsl NIM, Annex B P/N 1202889E1Operating Mode NetVanta Shdsl NIM, Annex a P/N 1200936E1Shdsl Interface NetVanta Shdsl NIM, Annex B NetVanta Shdsl NIM, Annex B P/N 1200937E1USB Interface Environmental NetVanta USB Wwan NIM P/N 1702803F1Dial Backup Interface Modules FeaturesNetVanta Analog Modem DIM P/N 1200864L1 NetVanta Isdn BRI DIM P/N 1200865L1 Etsi TBR NetVanta Isdn S/T DIM P/N 1200875L1Unit Installation Tools Required Mounting OptionsRack Mounting NetVanta 4300/4400 Series Wall Mounting NetVanta 4300/4400 Series Instructions for Wall Mounting the NetVantaStep Action NetVanta 4305 AC and NetVanta Supplying Power to the UnitNetVanta 4305 DC Instructions for Connecting DC Power Source to the NetVantaInstalling DIMs Installing Dial Backup and Network Interface ModulesNIM and DIM Installation Using a USB Cellular Modem with the NetVanta USB Wwan NIM NetVanta VPN Accelerator Card Installation Instructions for Installing the VPN Accelerator CardInstructions for Installing a Sodimm Installing a Sodimm for Expandable MemorySodimm Installation Keyed Slots Instructions for Installing a CompactFlash Card Installing a CompactFlash CardUnit Installation NetVanta 4300/4400 Series Table A-1 /100Base-T Ethernet Port Pinouts Name Description Appendix A. Connector PIN DefinitionsTable A-4. Console Port DCE Pinouts Name Description Table A-3. SFP Slot Pinouts NamePin Name Description Table A-5. WAN-DDS Connector Pinouts Name DescriptionTable A-6. WAN-T1 Connector Pinouts Table A-7. WAN-E1 Connector PinoutsTable A-11. WAN-SHDSL Connector Pinouts Table A-8. DSX-1 Connector Pinouts Name DescriptionTable A-9. G.703 Connector Pinouts Table A-10. WAN-ADSL NIM Connector PinoutsTable A-12. USB Wwan Connector Pinouts Name Description Table A-13. Serial to Cable PinoutsEIA Pin Table A-15. Isdn S/T DBU Connector Pinouts Dial Backup Interface Module Pinouts DBU Connector