3Com WL-575, 3CRWEASYA73 manual Snmp-server targets

Page 165

Using the Command Line Interface

•The command prompts for the following information to configure an SNMP v3 user:

-user-name- A user-defined string for the SNMP user. (32 characters maximum)

-group-name- The name of the SNMP group to which the user is assigned (32 characters maximum). There are three pre-defined groups: RO, RWAuth, or RWPriv.

-auth-proto- The authentication type used for user authentication: md5 or none.

-auth-passphrase- The user password required when authentication is used (8 – 32 characters).

-priv-proto- The encryption type used for SNMP data encryption: des or none.

-priv-passphrase- The user password required when data encryption is used (8 – 32 characters).

•Users must be assigned to groups that have the same security levels. If a user who has “AuthPriv” security (uses authentication and encryption) is assigned to a read-only (RO) group, the user will not be able to access the database. An AuthPriv user must be assigned to the RWPriv group with the AuthPriv security level.

•To configure a user for the RWAuth group, you must include the auth-protoand auth-passphrasekeywords.

•To configure a user for the RWPriv group, you must include the auth-proto,auth-passphrase,priv-proto,and priv-passphrasekeywords.

Example

Outdoor 11a Building to Building(config)#snmp-server user User Name<1-32> :chris

Group Name<1-32> :RWPriv Authtype(md5,<cr>none):md5 Passphrase<8-32>:a good secret Privacy(des,<cr>none) :des Passphrase<8-32>:a very good secret Outdoor 11a Building to Building(config)#

snmp-server targets

This command configures SNMP v3 notification targets. Use the no form to delete an SNMP v3 target.

6-53

Image 165

Contents User Guide 3Com Corporation 350 Campus Drive Marlborough, MA Contents Authentication Filter Control Advanced Setup System IdentificationConfiguring Snmp and Trap Message Parameters Configuring SntpCommand Line Interface Pin DIN to RJ-45 Cable Wiring B-6 Straight-Through Wiring Crossover Wiring B-4Terminology Viii Introduction Product FeaturesApproved Channels Radio Characteristics„ One Quick Start Guide Package ChecklistHardware Description Integrated HIGH-GAIN AntennaExternal Antenna Options Ethernet Port Power Injector ModuleWater Tight Test Point Grounding PointSystem Configuration Operating ModesWALL- and POLE-MOUNTING Bracket KIT POINT-TO-MULTIPOINT Configuration POINT-TO-POINT ConfigurationBeam Angle Page Bridge Link Planning Data Rates Radio Path Planning Antenna Height Miles 4.8 km 20 m 17 m 12 m Antenna Position and Orientation Weather Conditions Radio InterferenceGrounding Ethernet CablingHardware Installation Testing Basic Link Operation Using the POLE-MOUNTING BracketMount the Unit Fit the edges of the V-shaped Part into the slots Using the WALL-MOUNTING Bracket Page Connect External Antennas Connect Cables to the Unit Connect the Power InjectorPage LED Check the LED IndicatorsAlign Antennas High 11a Signal Page Networks Without a Dhcp Server Networks with a Dhcp ServerLaunching the 3COM Wireless Interface Device Manager Using the 3COM Installation CDClick on the Properties button to see the following screen First Time only Using the Setup WizardLogin Home page displays the Main Menu Setup Wizard Step Setup Wizard Step Setup Wizard Step Click Finish Click the OK button to complete the wizard System Configuration Advanced Setup Advanced SetupAdvanced Setup System Identification TCP / IP Settings System Configuration Smart Monitor Radius Radius Authentication Authentication Authentication Authentication Authentication System Configuration Filter Control System Configuration Vlan Filter Control Vlan ID Snmp Configuring Snmp and Trap Message ParametersSnmp Trap Configuration Configuring SNMPv3 Users Configuring SNMPV3 UsersChanging the Password AdministrationTelnet and SSH Settings Upgrading Firmware System Configuration „ IP Address IP address or host name of the Tftp server WDS and Spanning Tree Settings WDS and Spanning Tree Settings Root bridge acting as the master bridges parent WDS and Spanning Tree Settings Range Default Enabling System Logging System LOGError Level Description Configuring SntpRssi Rssi Radio Interface 802.11A Interface Radio Settings aRadio Settings a and B/G Configuring Common Radio SettingsSystem Configuration Normal Mode Turbo Mode System Configuration 802.11B/G Interface Radio Settings B/G Configuring WI-FI Multimedia Access WMM Access CategoriesCategory VoiceWMM Backoff Times System Configuration Key Type See Wired Equivalent Privacy WEP Wi-Fi Protected Access WPA or WPA2 Wireless Security ConsiderationsSecurity MAC Radius Combination Authentication b Server Radius Wired Equivalent Privacy WEPAuthentication and Encryption WPA Key Management WEP Keys Wi-Fi Protected Access WPA System Configuration WPA Configuration Settings Configuration settings for WPA are summarized belowAP Status Status InformationStation Status Static The client is using static WEP keys for encryption Security System Configuration Using the Command Line Interface Accessing the CLIConsole Connection Telnet Connection Keywords and Arguments Entering CommandsShowing Commands Command Modes Negating the Effect of CommandsConfiguration Commands Keystroke Commands Command GroupsGeneral Commands ConfigureGeneral Commands Command Mode Default SettingRelated Commands ExampleExit Command UsagePing SyntaxSyntax Reset board configuration ResetShow line Show historySystem Management Commands System Management CommandsCountry Country Codes Country countrycodeSyntax Prompt string no prompt PromptSyntax System name name no system name System nameUsername Syntax Username nameIp ssh-server enable PasswordIp telnet-server enable Default Setting Command ModeIp ssh-server port Syntax Ip ssh-server port port-numberIp http port Syntax No ip http server Default SettingSyntax Ip http port port-numberno ip http port Ip http serverSyntax Ip https port portnumber no ip https port Ip https portIp https server Syntax No ip https server Default SettingWeb-redirect Syntax No web-redirect Default SettingAPmgmtIP multiple IPaddress subnetmask single IPaddress any APmgmtIPAPmgmtUI Syntax APmgmtUI Snmp Telnet Web enable disableSnmp UI Show apmanagementUS United States Show systemShow version Show configSsid PRE Shared KEY WPA PSK Enabled Dot11StationRequestFail Nocountryset System Logging Commands System Loggign CommandsShow hardware Syntax No logging on Default Setting Logging onLogging host Syntax No logging console Default Setting Logging consoleLogging level Syntax Logging facility-type type Logging facility-typeSyntax Show logging Command Mode Syntax Logging clear Command ModeLogging clear Show loggingSyntax Show event-log Command Mode System Clock CommandsSystem Clock Commands Show event-logSyntax No sntp-server enable Sntp-server enableSntp-server ip Syntax Sntp-server ip 1 2 ipSntp-server ip 6-38 show sntp Sntp-server date-timeSntp-server daylight-saving Syntax No sntp-server daylight-saving Default SettingSntp-server timezone Syntax Sntp-server timezone hoursTAIPEI, Beijing Show sntpDhcp-relay enable Dhcp Relay CommandsSyntax No dhcp-relay enable Default Setting Dhcp Relay CommandsDhcp-relay Syntax Dhcp-relay primary secondary ipaddressShow dhcp-relay Snmp Commands Snmp CommandsDisplays the Snmp v3 notification filter assignments Snmp-server contact Snmp-server communitySnmp-server location Snmp-server host Snmp-server enable serverSnmp-server trap Hostname Name of the host. Range 1-63 charactersCommand Line Interface Snmp-server engine-id Syntax Snmp-server user user-name Snmp-server userSnmp-server targets Snmp-server filter Default Setting Show snmp groups Snmp-server filter-assignmentsSyntax Show snmp users Command Mode Syntax Show snmp groups Command ModeShow snmp users Show snmp group-assignmentsSyntax Show snmp target Command Mode Syntax Show snmp group-assignments Command ModeShow snmp target Show snmp filterShow snmp filter-assignments Syntax Show snmp filter-assignments Command ModeShow snmp Bootfile Flash/File CommandsSyntax Bootfile filename Flash/File CommandsCopy Syntax Copy ftp tftp file copy config ftp tftpDelete File information is shown below DirRadius Client Show bootfileRadius-server address Radius-server portSyntax Radius-server secondary port portnumber Syntax Radius-server secondary key keystring Radius-server keyRadius-server retransmit Syntax Radius-server secondary retransmit numberofretriesSyntax Radius-server secondary timeout numberofseconds Radius-server timeoutRadius-server port-accounting Syntax Radius-server secondary port-accounting portnumberRadius-server radius-mac-format Radius-server timeout-interimRadius-server vlan-format Syntax Radius-server vlan-format hex asciiShow radius 802.1X Authentication 802.1X Authentication 802.1xSyntax 802.1x supported required no Using the Command Line Interface Syntax 802.1x broadcast-key-refresh-rate rate 802.1x broadcast-key-refresh-rate802.1x session-timeout 802.1x session-key-refresh-rateSyntax 802.1x session-key-refresh-rate rate Default 802.1x-supplicant enable802.1x-supplicant user Show authentication MAC Address Authentication Syntax Address filter default allowed denied Address filter defaultAddress filter entry Syntax Address filter entry mac-addressallowed deniedAddress filter default 6-79 802.1x-supplicant user Syntax Mac-authentication server local remote Mac-authentication serverAddress filter delete Syntax Address filter delete mac-addressFiltering Commands Mac-authentication session-timeoutSyntax Mac-authentication session-timeout minutes Filter local-bridge Filtering CommandsOutdoor 11a Building to Building config#filter local-bridge Filter uplink enable Syntax No filter ap-manage DefaultSyntax No filter uplink enable Default Filter ap-manageSyntax No filter ethernet-type enable Default Filter ethernet-type enableShow filters Filter ethernet-type protocolWDS Bridge Commands WDS Bridge CommandsSyntax Bridge mode master slave Bridge modeBridge role WDS Syntax Bridge role ap repeater bridge root-bridgeBridge channel-auto-sync Syntax Bridge channel-auto-sync enable disableSyntax Bridge-link parent mac-address Bridge-link parentBridge-link child Syntax Bridge-link child index mac-addressSyntax Bridge dynamic-entry age-time seconds Bridge dynamic-entry age-timeSeconds Show bridge aging-time Show bridge filter-entry MAC Show bridge link Syntax Show bridge link ethernet wireless a g indexParent 00-12-34-56-78-9a Child Spanning Tree Commands Bridge stp enableBridge Commands Bridge stp forwarding-delay Syntax No bridge stp enable Default SettingBridge stp hello-time Syntax Bridge stp hello-time time No bridge stp hello-timeBridge stp max-age Syntax Bridge stp max-age seconds No bridge stp max-age Bridge stp prioritySyntax Bridge stp prioritypriority no bridge stp priority Syntax Bridge-link path-cost index cost Bridge-link path-costBridge-link port-priority Syntax Bridge-link port-priority index priorityShow bridge stp Ethernet Interface Commands Syntax Show bridge stp Command ModeEhternet Interface Commands Dns server Interface ethernetIp address ip-address netmask gateway no ip address Ip addressIp dhcp Syntax No ip dhcp Default SettingSpeed-duplex Syntax No shutdown Default SettingSyntax Speed-duplex auto 10MH 10MF 100MF 100MH ShutdownShow interface ethernet Syntax Show interface ethernet Default SettingWireless Interface Commands Wireless Interface CommandsSyntax Interface wireless a g Interface wirelessVap SpeedSyntax Speed speed Syntax Turbo static dynamic no turbo TurboSyntax Multicast-data-rate speed Multicast-data-rateSyntax Channel channel auto ChannelTransmit-power Radio-modeSyntax Radio-mode b g b+g Default Setting +g mode Command Mode PreambleSyntax Preamble long short-or-long Syntax Antenna control diversity left right Antenna controlSyntax Antenna id antenna-id Antenna idAntenna location Syntax Antenna location indoor outdoorSyntax Beacon-interval interval Beacon-intervalSyntax Dtim-period interval Dtim-periodSyntax Fragmentation-length length Fragmentation-lengthRts-threshold Syntax Rts-threshold thresholdSuper-a Syntax No super-a Default SettingSyntax No super-g Default Setting Super-gDescription Syntax No closed-system Default Setting SsidClosed-system Syntax Assoc-timeout-interval minutes Assoc-timeout-intervalMax-association Syntax Max-association countSyntax Auth-timeout-value minutes Auth-timeout-valueSyntax Show interface wireless a g vap-id Show interface wireless130 131 132 Show station Rogue AP Detection CommandsRogue AP Commands Rogue-ap enableSyntax No rogue-ap authenticate Default Setting Rogue-ap authenticateRogue-ap duration Syntax Rogue-ap duration millisecondsRogue-ap interval Rogue-ap scan Syntax Rogue-ap interval minutes138 Wireless Security Commands Wireless Security CommandsShow rogue-ap Auth 141 Encryption Syntax No encryption Default SettingKey index size type value no key index KeyTransmit-key Syntax Transmit-key indexKey 6-143 encryption 6-142 transmit-key Syntax Cipher-suite aes-ccmp tkip wep Cipher-suiteSyntax Micmode hardware software MicmodeSyntax Wpa-pre-shared-key hex passphrase-keyvalue Wpa-pre-shared-keySyntax Pmksa-lifetime minutes Pmksa-lifetimePre-authentication Syntax No link-integrity ping-detect Default Setting Link Integrity CommandsLink Integrity Commands Link-integrity ping-detectLink-integrity ping-host Link-integrity ping-intervalSyntax Link-integrity ping-interval interval Link-integrity ping-fail-retry Syntax Link-integrity ping-fail-retry countsLink-integrity ethernet-detect Iapp Commands Syntax No link-integrity ethernet-detect Default SettingShow link-integrity Vlan Commands Syntax No iapp DefaultIapp Vlan Commands Command Description Syntax No vlan enable DefaultVlan Management-vlanidSyntax Vlan-id vlan-id Vlan-idWMM Commands WMM CommandsWmm Syntax No wmm supported requiredSyntax Wmm-acknowledge-policy acnumber ack noack Wmm-acknowledge-policyWmmparam AP Access Point BSS Wireless client161 162 Troubleshooting Page Page Page TWISTED-PAIR Cable Assignments Cables and Pinouts10/100BASE-TX PIN Assignments STRAIGHT-THROUGH Wiring Crossover Wiring Pin DIN Ethernet Port Pinout PIN DIN Connector PinoutPIN DIN to RJ-45 Cable Wiring Glossary CSMA/CA Infrastructure Radius Virtual LAN Vlan Glossary-6 Index RTS STA

Related manuals

Manual 20 pages 14.36 Kb