3Com 32x, 52x manual Upgrading Memory, Removing the Cover

3

UPGRADING MEMORY

The following memory upgrades are available from 3Com for your bridge/router:

■4 MB (3C8104) flash memory

■4 MB DRAM (3C8040)

Complete the following sections to install flash memory or DRAM in your SuperStack II bridge/router.

CAUTION: If you install the flash memory upgrade and then remove it from your system after startup, you will need to reload the system software using the procedures described in the software guide.

Removing the Cover

1Turn off the power and unplug the power cord from your SuperStack II bridge/router. Unplug the RPS cable, if connected.

2Remove the two screws on the back of the bridge/router.

MODEL: ESPL-310		S/N:
NETBUILDER				1SC05427
REMOTE OFFICE
327		NTWK	080002	04BA1E	LAN	8.3
100-240VAC, 50/60HZ, 1.0-0.5A		ADDR:		04BA1F	WAN-A
	250V, F2A			04BA20	WAN-B
				04BA21	WAN-C
FOR CONTINUED PROTECTION
AGAINST FIRE HAZARD
REPLACE FUSE ONY WITH					20-0261-000
SAME TYPE AND RATING		07/31/95
3COM CORP. SANTA CLARA, CA.					MADE IN USA

Remove these two screws

3Slide the cover back and up off the bridge/router.