42Chapter 2: Installation
T1 interface to DSU/CSU
Introduction to the T1 interface T1 interface, which stands for channelized CT1/PRI interface, is responsible for forwarding and processing T1 data flow, delivering CT1 access and implementing ISDN PRI function. Its attributes are listed in the following table:
Table 18 T1interface attributes
Attribute | Description |
|
|
Connector type | RJ45 |
Interface standard | G.703/T1 102, G.704 |
Maximum baud rate | 1.544Mbps |
Matching cable | T1 cable (100Ω standard shielded cable) |
Operating mode | T1, CT1, ISDN PRI |
Function | Backup |
| Terminal access |
| ISDN |
|
|
For the T1 module, corresponding serial interface shall be created after you use the timeslot bundling command on the Controller T1 interface.
T1 interface cable T1 interface matches 100Ω standard shielded cable. See the following figure:
Figure 30 T1 interface cable
You can also choose to use network connector assembly, for extending two T1 interface cables.
T1 interface cable and network connector assembly are optional.