3Com 5000 manual Setting the connection port in the local configuration

44Chapter 3: Starting and Configuring the Router 5000

Setting terminal parameters Follow these steps to set the parameters of the Hyper Terminal in Windows98:

1Select a connection port.

Select the serial interface to be connected in the [Connect using] box, as shown in Figure 32. Please note that the selected serial interface should be consistent with the actual serial interface connected by the console cable.

Figure 32 Setting the connection port in the local configuration

2Set the serial interface parameters. As shown in Figure 33, in the properties dialog box of the serial interface, set the baud rate to 9600, data bit to 8, no parity check, stop bit to 1, and flow control to none. Then, click <OK> to return to the HyperTerminal window.