•Your scanner automatically rounds the entered frequency to the nearest valid frequency. For example, if you enter a frequency of 151.473, your scanner accepts it as 151.470.
•Press FUNC then press DELAY/1 to turn the delay function on or off. If you want the scanner to pause 2 seconds on this channel after a transmis- sion ends before it proceeds to the next active transmission, see “Using the Delay Function” on Page 48. The scanner also stores this setting in the channel.
•If you are storing frequencies for an EDACS sys- tem, you must store them in logical channel num- ber order, with the first frequency in channel 1 for the current bank.
5.If necessary, press MODE to change the receiving mode. If you select P/L or DPL, enter the PL or DPL code by pressing STEP (to move through the codes upward) or FUNC then press STEP (to move down- ward through the codes).
6.If desired, program a text tag for the channel (see “Assigning a Text Tag to a Channel”).
7.The next channel in sequence is ready for program- ming. Press PGM and then repeat Steps 3 through 5.
STORING TEXT TAGS
You can customize your scanner by storing text tags (up to 12 characters) for easy identification of channel trans- missions, trunk ID’s, or banks.
Assigning a Text Tag to a Channel
To input the text, follow these steps:
1.Press MANUAL, enter the channel number where you want to enter the text, then press MANUAL again. M and the channel number appear at the upper left corner on the display (for example: M100).
2.Pressing PGM changes M to P on the display.
37